Burley PRE-2005, PRE-2004 warranty Burley Walk ‘n Roller Manual models 2003 and earlier

Page 4

NOTE: if you have a 2004 Encore, this step is not necessary.

Locate the replacement parts for the roll bar catch and hinge, and their counterparts on the trailer (see the figure, top of next page). The “catch” is located on the trailer’s right, the “hinge” is on the left.

First remove the old hinge from the left side of the trailer by removing the hex head bolt that attaches the roll bar. Then remove the Phillips head screw that holds the hinge to the frame. Save both the hex head and Phillips bolts for installing the new hinge.

Fasten the new hinge onto the trailer’s left side using the #3 driver, the existing Phillips head bolt and the new standard nut provided. The nut will fit snugly into the hex shape recess in the center of the part. Tighten securely.

4

Burley Walk ‘n Roller Manual; models 2003 and earlier

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Pre-2004 d’Lite, Lite & Pre-2005 Encore Introduction II. Preparation for Installation III. Handlebar InstallationParts included for the Handlebar Assembly Tools RequiredBurley Walk ‘n Roller Manual models 2003 and earlier Burley Walk ‘n Roller Manual models 2003 and earlier IV. Using the Handle Receiver that directs the handle upward toward the backParts Included for the Pivot wheel Assembly Attachment Mount Wheel Pivot AssemblyTemporary Hitch Removal Re-Assembly with the Pivot Wheel VII. Installing the Brake VI. Using the Walk n’ Roller WheelParts Needed for Brake Installation Burley Walk ‘n Roller Manual models 2003 and earlier VIII. Safety Guidelines IX. Maintenance Burley Walk n’ Roller Limited Warranty
Top Page Image Contents