Burley PRE-2004, PRE-2005 warranty Mount Wheel Pivot Assembly, Temporary Hitch Removal

Page 7

Always check the handle attachment before using. Be sure that handle is properly installed with buttons protruding in the locked position. Failure to do this could lead to loosening of handle, loss of control, and serious injury.

V. Mount Wheel Pivot Assembly

Parts Included for the Pivot wheel Assembly Attachment:

(1)	1/4 x 2” hex bolt	(1) Pivot Wheel Assembly
(3)	1/4” locking nuts	(3) 1/4 x 1” hex bolts
(3)	5/8” washers

Temporary Hitch Removal

Before installing the Wheel Pivot Assembly, the hitch has to be removed from the end of the tongue. Loosen and remove the securing bolt, #1 in the drawing on the next page.

•As you remove the bolt, notice how it secures the hitch though the hitch connector (#2) and the safety strap (#4).

•Save the hitch and the d-ring (#3) for reinstallation. The locking nut (#5) and the bolt (#1) can be discarded. A longer bolt is provided for the next step.

1

32

5	4

7

Burley Walk ‘n Roller Manual; models 2003 and earlier

Image 7

Contents Pre-2004 d’Lite, Lite & Pre-2005 Encore Introduction Tools Required II. Preparation for InstallationIII. Handlebar Installation Parts included for the Handlebar AssemblyBurley Walk ‘n Roller Manual models 2003 and earlier Burley Walk ‘n Roller Manual models 2003 and earlier Receiver that directs the handle upward toward the back IV. Using the HandleParts Included for the Pivot wheel Assembly Attachment Mount Wheel Pivot AssemblyTemporary Hitch Removal Re-Assembly with the Pivot Wheel VII. Installing the Brake VI. Using the Walk n’ Roller WheelParts Needed for Brake Installation Burley Walk ‘n Roller Manual models 2003 and earlier VIII. Safety Guidelines Burley Walk n’ Roller Limited Warranty IX. Maintenance