Burley PRE-2005 IV. Using the Handle, Receiver that directs the handle upward toward the back

Page 6

Insert the Handle receivers, on right and left side using 1-1/8” bolts and locking nuts provided. The right and left receivers are side speciﬁc. Be sure to mount the

receiver that directs the handle upward toward the back.

IV. Using the Handle

Install the handle from the rear of the trailer. The trailer must be in the running, unfolded position. The handle needs to be removed to fold the trailer. It may remain on while towing the trailer behind a bicycle.

The handle height is adjusted by inserting the handle with the bend upward for high, or ﬂipped over with the bend downward, for low (see image below).

To insert the handle, depress the button on both sides, simultaneously, while inserting into the receivers.

The receivers have an oval hole, as shown, for the button to protrude through when inserted. The button locks the handle into the receiver. Be sure that both buttons are protruding through the hole in the receivers. This will prevent the handle from coming out during use.

6

Burley Walk ‘n Roller Manual; models 2003 and earlier

Image 6

Contents Pre-2004 d’Lite, Lite & Pre-2005 Encore Introduction Parts included for the Handlebar Assembly II. Preparation for InstallationIII. Handlebar Installation Tools RequiredBurley Walk ‘n Roller Manual models 2003 and earlier Burley Walk ‘n Roller Manual models 2003 and earlier IV. Using the Handle Receiver that directs the handle upward toward the backMount Wheel Pivot Assembly Parts Included for the Pivot wheel Assembly AttachmentTemporary Hitch Removal Re-Assembly with the Pivot Wheel VI. Using the Walk n’ Roller Wheel VII. Installing the BrakeParts Needed for Brake Installation Burley Walk ‘n Roller Manual models 2003 and earlier VIII. Safety Guidelines IX. Maintenance Burley Walk n’ Roller Limited Warranty