Remote control
Preparation for Use
Battery installation
Use 2 “AA” size batteries
1Open the battery cover.
2Insert the batteries according to the direction indicated in the battery compartment (back of the battery cover).
When inserting or removing the batteries, push them towards the 
battery terminals.
3Close the battery cover.
Precautions for battery use:
Replace all old batteries with new ones at the same time. Do not mix old and new batteries.
Remove the batteries if the unit will not be used for long periods of time. This will prevent potential damage due to battery leakage.
Caution:
Do not use rechargeable batteries
Battery removal:
Open the battery cover and pull up the battery to take out.
Notes concerning use:
Replace the batteries if the operating distance is reduced or if the operation becomes erratic.
Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit.
Keep the remote control away from moisture, heat, shock, and vi- brations.
Test of the remote control
Check the remote control after checking all the connections (see pages 9 - 11).
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below: Press the
Remote sensor
0.2 m - 6 m
(8" - 20')
12
17/03/05