Spindle Lock
The spindle lock will assist you in replacing the spindle or installing and removing cutters.
NOTE: The spindle lock can be engaged only when the machine has stopped completely.
1.Open rear cabinet door.
2.Pull out the knurled part of the lock knob (A, Figure 21) and rotate it 180 degrees until the opposite hole in the knurled lock knob engages the pin. The spindle is now locked.
3.To release the spindle, pull out the knurled lock knob and rotate it 180 degrees until it engages the pin.
Make sure the spindle is unlocked before turning on the machine.
Spindle Vertical Travel
1.Loosen handwheel lock (A, Figure 22) and turn handwheel (B, Figure 22) counterclockwise to raise the spindle; clockwise to lower the spindle.
NOTE: One complete revolution of the handwheel moves the spindle up or down by 0.1" (2.5mm), as shown on the label beside the handwheel.
2.
Spindle Tilting
The machine should come to a complete stop before the spindle is tilted, and the insert with the oval slot should be placed into the table. Make sure the cutter does not touch the table or the fence when in tilted position.
1.Loosen the knob (C, Figure 22) on the front handwheel (D, Figure 22).
2.Loosen the two locking handles (E, Figure 22) on both sides of the machine.
3.Turn the handwheel (D, Figure 22) to the required tilting angle shown on the indicator (F, Figure 22).
4.Tighten the knob (C, Figure 22) and locking handles (E, Figure 22).
15
Figure 21
Figure 22