Introduction
This manual is provided by Powermatic covering the safe operation and maintenance procedures for a Model TS29 Tilting Spindle Shaper. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide years of trouble free operation if used in accordance with instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or Powermatic. Powermatic can also be reached at our web site: www.powermatic.com.
Specifications |
|
Model Number | TS29 |
Stock Number | 1791284 |
Motor | 7.5HP, 3Ph, 230/460V (Prewired 230V) |
Electric controls | 24 volt magnetic |
Interchangeable Spindle Sizes (with Capacity Under Nut) (in.) | |
| and 1/2 collet chuck with 1/4 bushing |
Spindle Vertical Travel (in.) | 7 |
Spindle Speeds (RPM) | 3000, 4000, 6000, 8000 and 10,000 |
Spindle Tilt (degrees) | 5 back, 45 forward |
Overall Table Size (L x W) (in.) | |
Sliding Table Size (L x W) (in.) | |
Sliding Table Travel (in.) | |
Maximum Diameter Cutter Below Table (in.) | 9 |
Maximum Diameter Cutter Above Table (in.) | 12 |
Table Inserts (in.) | three: |
Fence Size (with Mechanical Digital Readouts) (in.) | 46 x 5 |
Fence Travel (Major and Minor) (in.) | |
Dust Port Diameter (two) (in.) | 5 |
Dust Collection Minimum CFM Required | 800 |
Shipping Weight (lbs.) | 1280 |
Net Weight (lbs.) | 1100 |
Overall Dimensions (L x W x H) (in.) | 51 x 44 x 53 |
The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, Powermatic reserves the right to change specifications at any time and without prior notice, without incurring obligations.
7