Powermatic TS29 operating instructions Troubleshooting

Troubleshooting

Trouble

Machine will not start.

Overload kicks out frequently.

Cutter does not come up to speed.

Machine makes unsatisfactory cuts.

Workpiece burns.

Machine vibrates excessively.

Edge splits off on cross-grain cut.

Probable Cause	Remedy [with page #]
Not connected to power source.	Check connection.
Cord damaged.	Have cord replaced by authorized
	service person.
Connected to wrong voltage.	Check voltage.
Faulty switch.	Replace switch.
Fuse blown or circuit breaker tripped	Replace fuse, reset breaker.
at incoming power source.
Extension cord too light or too long.	Replace with adequate size cord.
Feeding stock too fast.	Feed stock more slowly.
Cutter is dull or has gum on it.	Clean or replace cutter. [10]
Extension cord too light or too long.	Replace with adequate size cord.
Low current.	Contact local electric company.
Motor not wired for correct voltage.	Refer to motor nameplate for correct
	wiring.
Spindle is locked.	Release spindle lock knob. [15]
Dull cutter.	Replace cutter. [10]
Gum or pitch on cutter.	Remove cutter and clean with
	turpentine and steel wool.
Gum or pitch on table causing erratic	Clean table with turpentine and steel
feed.	wool.
Feeding work in wrong direction.	Feed work against cutter rotation. [5]
Dull cutter.	Sharpen by honing on the flat side.
Cut is too deep.	On hardwoods take light cuts; attain
	full depth of cut with several passes.
The work is being forced.	Feed slowly and steadily.
Damaged cutter	Replace cutter. [10]
Machine is on uneven floor.	Reposition on flat, level surface.
Bad v-belt.	Replace belt.
V-belt not tensioned properly.	Adjust belt tension. [14]
Bent pulley.	Replace pulley.
Improper motor mounting.	Check and adjust motor mounting.
	Make cross-grain cuts first, then finish
Characteristic of cut.	with-grain. Use scrap block for
	support at end of cut.

21