Stage 2 - Sit & Play
1 | To change from Stage 1 to Stage 2 |
• Turn the threaded knobs | |
detach the leg assemblies from the keyboard. |
•Press the star buttons and remove the two supports from the legs. Now proceed to step 2.
If you have not used this toy before and are assembling it for first time use in Stage 2, start with Step 2.
2 | Support |
Leg |
Star Button
Large Slot
•While pressing the star buttons on a support, fit the end of the support into the large slot in one of the legs, as shown. The support should “snap” in place.
•Repeat this procedure to attach the other support to the remaining leg.
3
Knob
Stage Switch
•Slide the stage switch to 
for use with babies sitting up.
Hint: If your child is not actively playing with this toy, it turns off automatically (sleep mode).
•Be sure to slide the stage switch to the off 
position when not in use.
Leg Assembly | Leg Assembly |
•Position the keyboard so it faces up.
•Fit a leg assembly to the side of the keyboard, as shown.
•Turn the knob clockwise to secure the leg assembly to the keyboard. Make sure the knob is fully tightened.
•Repeat this procedure to attach the other leg assembly to the keyboard.
4
Tab
Mode Switch | Volume Switch |
•Slide the mode switch to 
. When baby presses a key, part of a song plays with twinkling lights. With each press of a key, the song continues building, a little at a time.
•Slide the mode switch to 
. When baby presses a key, musical scales or chords play as twinkling lights follow along.
•Locate the volume switch on the bottom of the keyboard. Adjust volume to high 
; or low 
, for your child’s comfort.
Hanger
• | Rotate the hangers up and “snap” them into place. | 5 |
• | Attach the toys to the hangers and tabs as shown. |