Stanley Black & Decker CT04 user manual Tool Protection & Care

Page 14

TOOL PROTECTION & CARE

NOTICE

In addition to the Safety Precautions found in this manual, observe the following for equipment protection and care.

Make sure all couplers are wiped clean before con- nection.

The hydraulic circuit control valve must be in the

“OFF” position when coupling or uncoupling hydrau- lic tools. Failure to do so may result in damage to the quick couplers and cause overheating of the hy- draulic system.

Always store the tool in a clean dry space, safe from damage or pilferage.

Make sure the circuit PRESSURE hose (with male quick disconnect) is connected to the “IN” port. The circuit RETURN hose (with female quick disconnect) is connected to the opposite port. Do not reverse cir- cuit flow. This can cause damage to internal seals.

Always replace hoses, couplings and other parts with replacement parts recommended by Stanley Hydraulic Tools. Supply hoses must have a mini- mum working pressure rating of 2500 psi/172 bar.

Do not exceed the rated flow. Refer to Specifications in this manual for correct flow rate. Rapid failure of the internal seals may result.

Always keep critical tool markings, such as warning stickers and tags legible.

Do not force a small tool to do the job of a large tool.

Tool repair should be performed by experienced personnel only.

Make certain that the recommended relief valves are installed in the pressure side of the system.

Do not use the tool for applications for which it was not intended.

14 ► CT04 User Manual

Image 14
Contents Hydraulic Crimping Tool Page Table of Contents Safety Symbols Local Safety RegulationsSafety Precautions Tool Stickers & Tags Do not Operate Without DiesHose Safety Tags Hose TypesHose Recommendations Htma / Ehtma Requirements Htma Tool Type Hydraulic System Requirements Type RRDIE Installation Setup and TestOpen CENTER/CLOSED Center Setup OperationOC/CC Setting To Install Dies on Kearney O Style HeadTo Install Dies on Burndy W Style Head Check Power SourceConnect Hoses Tool Relief Valve AdjustmentOperation Conductor PreparationStorage Cold Weather OperationShutdown Tool Protection & Care Troubleshooting Problem Cause SolutionSpecifications CT04 Illustration CT04 Parts List Part QTY DescriptionPage Stanley Hydraulic Tools SE Naef Road Milwaukie, Oregon