Battery Replacement

1.5V x 3

“AA” (LR6)

Shown Actual Size

Battery Compartment Door

For best performance, we recommend replacing the batteries that came with this toy with three, new alkaline “AA” (LR6) batteries.

•Locate the battery compartment on the bottom of the toy.

•Loosen the screws in the battery compartment door with a Phillips screwdriver. Remove the battery compartment door.

•Insert three “AA” (LR6) alkaline batteries, as indicated inside the battery compartment.

Hint: We recommend using alkaline batteries for longer life.

•Replace the battery compartment door and tighten the screws with a Phillips screwdriver. Do not over-tighten.

•When lights or sounds from this toy become faint or stop, it’s time for an adult to change the batteries!

Battery Safety Information

Batteries may leak fluids that can cause a chemical burn injury or ruin your toy. To avoid battery leakage:

•Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).

•Insert batteries as indicated inside the battery compartment.

•Remove batteries during long periods of non-use. Always remove exhausted batteries from the toy. Dispose of batteries safely. Do not dispose of batteries in a fire. The batteries may explode or leak.

•Never short-circuit the battery terminals.

•Use only batteries of the same or equivalent type, as recommended.

•Do not charge non-rechargeable batteries.

•Remove rechargeable batteries from the toy before charging.

•If removable, rechargeable batteries are used, they are only to be charged under adult supervision.

FCC Note (United States Only)

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Consult the dealer or an experienced radio/TV technician for help.

Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.