Sennheiser EMP 2015 manual Getting ready, Setting up the EMP, Inserting and replacing the battery

6 Getting ready

EMP 2015 receiver/amplifier combination

Setting up the EMP 2015

The EMP 2015 is equipped with a temperature-controlled ventilation system. To ensure sufficient ventilation, please make sure that the ventilation apertures at the side panels are not covered. An integrated temperature monitoring device protects the EMP 2015 against overheating by turning it off if the temperature rises above a certain value. After sufficient cooling, the EMP 2015 is automatically turned on again.

Connecting the antenna and preparing the mains connection
Antenna
￿ Connect the supplied telescopic antenna to the BNC socket	at the
rear of the EMP 2015 and lock the bayonet catch.

￿Pull out the antenna and align it.

Note:

For optimum reception, align the transmitting and receiving antenna vertically.

Mains connection

￿ Plug the power cord into socket at the rear of the EMP 2015.

SK 500 bodypack transmitter

Inserting and replacing the battery
￿ Slide the cover of the battery compartment	in the direction of the
embossed arrow until it clicks audibly.

￿Open the cover.

￿Insert the 9 V PP3 battery (IEC 6 LR 61). Please observe correct polarity when inserting the battery.

￿Close the battery compartment.

￿ To remove the battery, push the red lever	in the battery compartment
towards the bottom side of the transmitter.

Note:

If powered by a standard PP3 battery, the operating time of the transmitter is approx. 6 hours. If powered by a rechargeable battery, the operating time is approx. 4 hours. Special note on rechargeable battery operation: For optimum operation, only use 9.6 V / 160 mAh NiMH batteries.

44