Turning the system components on and off
Turning the amplifier on/off
The amplifier is fitted with both a mains switch and an operating switch
.Via the mains switch, the amplifier can be disconnected from the mains (position “0”). The mains switch can always remain set to “I”.
When putting the system into operation, turn the amplifer on by setting
the mains switch | to “I”. The mains switch can then remain set to “I”. |
During normal operation, turn the amplifier on or off by using the operating switch .
To disconnect the amplifier from the mains, set the mains switch to “0”.
Turning the receiver section on/off |
|
|
|
The receiver section is fitted with a separate ON / OFF switch | which can | ||
always remain set to “ON”. |
|
|
|
Adjusting the volume of the microphone |
|
| |
Set the MICROPHONE volume control | to “0” before you turn the | ||
amplifier on. Adjust the volume of the microphone after | |||
Adjusting the volume of connected audio devices |
| ||
Set the LINE IN volume control | to “0” before you turn the amplifier on. | ||
Adjust the volume of the connected audio devices after |
| ||
Note: |
|
|
|
With the two volume controls | and , the microphone and LINE IN | ||
signals can be mixed for reproduction at the loudspeaker output.
Turning the transmitter on/off
Slide back the cover plate .
Press the ON / OFF button to turn the transmitter on. The red LED lights up.
To turn the transmitter off, press and hold the ON / OFF button until “OFF” appears on the display. You can then release the button. The red
LED goes off. |
|
Muting the transmitter |
|
Use the MUTE switch | to noiselessly mute the transmitter’s audio signal |
(this switch does not turn off the transmitter).
48
