Section 9 - Installing the Car Seat Base with Vehicle Belts 33
Some vehicle seats do not provide enough support to hold the base up at the required angle.
If extra support iis required a tightly rolled towel or a firm foam roll (pool noodle) can be used.
Any extra support used to hold the car seat up must not interfere with the Vehicle Belts.
Section 9 - Installing the Car Seat Base with Vehicle Belts 34
FITTING THE CAR SEAT INTO THE BASE.
Before putting the car seat into the base make sure there are no objects on or in the base.
"CLICK" | Connect the car seat to the base. |
|
NOTE: listen for a "CLICK" when the car seat is installed into the base, and lift the car seat to ensure the car seat is fully conected to the base.
To remove the carseat from the base, pull firmly upwards on the release lever at the rear of the car seat, and lift the carseat upwards.
WARNING: DO NOT use the car seat if it is not securely connected to the base.