Storing the Latch Connectors, Releasing the Chest Clip

Child Seat Functions

Storing the LATCH Connectors

When the LATCH connector is not in use, lift the cover to access the LATCH storage slots (Fig. A). Fold the LATCH adjuster and the connector, then slide each set into the adjacent slot.

	NOTE: Child seats are shipped from Britax with the
	LATCH connectors in the storage slots.		a
	Recline Adjustment

Pull the recline handle (Fig. B) then slide the child seat shell into the desired position. Release the recline handle, then verify the child seat has locked into position.

	WARNING!
	WARNING!
• This child seat must be in the reclined		b
	position when used rear-facing.	b
• This child seat must be in full upright position


	when installed forward-facing for children who

Chest Clip

Fastening the Chest Clip

Fasten the chest clip by pushing the two halves together until a positive click is heard (Fig. D).

Releasing the Chest Clip

1Squeeze the middle tabs together (Fig. E).

2Pull the two pieces apart.

Adjusting the Chest Clip

1Slide the chest clip up or down (Fig. F) on the harness so it is positioned at the middle of the child’s chest, level with the child’s armpits.

2Slide the HUGS™ chest pads and comfort pads to a comfortable location for the child.

HUGS™ Chest Pads

weigh more than 33 lbs (15.1 kg).
NOTE: It will be necessary to loosen the tether,
vehicle seat belt, and/or LATCH strap before
adjusting the recline position. The tether, vehicle
seat belt, and/or LATCH strap must be properly re-	c
tightened after adjusting the recline position.	c

Infant Body Pillow

The Infant Body Pillow is designed to provide better fit and comfort for infants using this child seat. For additional side support, fold the side flaps inward (Fig. C).

NOTE: Remove the Infant Body Pillow after child can sit comfortably in the child seat without additional support.

WARNING! HUGS™ chest pads must be installed for forward-facing use. Removal of HUGS is optional only for rear- facing use.