Britax CS manual Figure a illustrates a forward-facing, lap-belt installation

Page 13

Installation: Forward-Facing

Installation: Forward-Facing

Lap-Belt Installation

Figure A illustrates a forward-facing, lap-belt installation.

When not in use, always store the LATCH connectors in the storage slots. See page 30.

WARNING!

This child seat must not be used forward-facing for children less than one year of age OR who weigh less than 20 lbs (9.1 kg).

This child seat must be in full upright position when installed forward-facing for children who weigh more than 33 lbs (15.1 kg).

a

b

4Verify that the vehicle belt is not twisted, is routed under the LATCH bars, then buckle (Fig. B).

5Push the child seat firmly into the vehicle seat while removing slack from the vehicle belt (Fig. C).

6 Attach the Versa-Tether®hook to the

c

designated tether anchor (if available

according to the vehicle owner’s manual)

 

 

for the chosen seating position. Remove all slack from the tether to secure. Store excess webbing in the tether pouch. See pages 25–28.

7Verify that the vehicle belt is tight, locked and the child seat is secure.

The child seat is secure when it cannot be moved front-to-back or side-to-side more than 1 in. (2.5 cm) at the belt path. If the child seat is not secure, repeat this procedure or use an alternate seating location.

IMPORTANT: Britax recommends that the Versa-Tether be used at all times. Using the tether will improve the stability of the child seat and reduce the risk of injury. Check your vehicle owner’s manual for approved tether locations.

1Place the child seat forward-facing on the vehicle seat. Ensure the bottom of the child seat base is in full contact with the vehicle seat.

TIP:You may need to raise or remove the vehicle head restraint to achieve best fit of the child seat.

2If the vehicle is equipped with a designated tether anchor for the chosen seating position, remove the Versa-Tether from the pouch and place it up and over the child seat back.

3Pull the vehicle belt out, then pass it under the LATCH bar, through the forward-facing belt path, then under the LATCH bar on the opposite side (Fig. B).

22

23

Image 13
Contents Boulevard CS Table of Contents Page Important Notes Safety InformationCertification RegistrationRear-Facing Important Harness AdjustmentsForward-Facing Forward-Facing Harness HeightChild Seat Features Incompatible Vehicle Seat Belts Vehicle CompatibilityVehicle Buckle Positions Vehicle Seating PositionsLatch Installation Installation Rear-FacingVehicle belt can be routed over or under cover Lap-Shoulder Belt InstallationFigure a illustrates a rear-facing, lap-belt installation Lap-Belt InstallationLatch Installation Installation Forward-FacingFig. E Figure a illustrates a forward-facing, lap-belt installation Installation Versa-Tether Installation AircraftRear-Facing Installation Forward-Facing InstallationTether Connector Strap Using the Versa-TetherSwitching the Latch Connectors Installation Versa-Tether Child Seat FunctionsEnergy-Absorbing Tether Adjusting the Chest Clip Storing the Latch ConnectorsChest Clip Fastening the Chest Clip Releasing the Chest ClipHarness Buckle Fastening the Harness Buckle How to Adjust Harness HeightReleasing the Harness Buckle Buckling and Tightening the Harness Securing Your ChildCare and Maintenance Harness Buckle Removal Cleaning the Harness BuckleRe-threading the Harness Buckle Limited ONE-YEAR Warranty WarrantyPage Checklist before tightening harness Click & Safe Snug Harness Indicator
Related manuals
Manual 23 pages 26.42 Kb