Britax Regent manual Cover Removal, Care and Maintenance

Page 19

Care and Maintenance

Cover Removal

WARNING! Do not take apart the harness. Never remove the buckle tongues from the harness. They cannot be reattached after removal. If reassembled incorrectly, the child

seat may not perform as intended.

1Loosen the harness by lifting the harness adjuster lever while pulling the shoulder straps forward as far as possible.

2Unhook the shoulder straps from the harness yoke on the rear of the child seat (Fig. A).

3Pull the upper harness straps through the A shell and cover to the front of the child seat.

4Remove the buckle and belly pad. See page 36.

5Gently remove the upper portion of the cover. Be careful not to damage the energy-absorbing foam.

6Pull the lower harness straps, buckle tongues, HUGS™ chest pads, and chest clip through the lower slots in cover.

7Remove the entire cover from the child seat.

For additional demonstration please visit www.BritaxUSA.com.

Refitting the Cover

To refit the cover, reverse the above directions. Make sure that the shoulder straps are not twisted, and are threaded properly through the chest clips, cover, foam, and shell.

Care and Maintenance

Cleaning the Cover

sHAND WASH using cold water and mild soap.

sLINE or LIE-FLAT DRY to prevent the cover from shrinking.

sDO NOT bleach, machine wash, machine dry or iron.

Cleaning the Shell

sSPONGE CLEAN using warm water and mild soap.

sTOWEL DRY

sDO NOT use solvents, abrasive cleaners or disassemble the harness.

Cleaning the Harness

sSPONGE CLEAN using warm water and mild soap.

sTOWEL DRY

sDO NOT bleach, machine wash, machine dry or disassemble the harness.

Cleaning the Harness Adjuster

Periodically check the adjuster area to be sure it is clean and free of food, drink or other debris. If debris is present, it must be removed to prevent interference with the adjuster mechanism.

sBRUSH AWAY LOOSE DEBRIS using a soft-bristled brush.

sSPONGE CLEAN using warm water and a mild soap.

sTOWEL DRY

sDO NOT use solvents, abrasive cleaners or disassemble the harness.

34

35

Image 19
Contents Page Table of Contents Never route the vehicle belt over the child Certification Safety InformationRegistration Forward-Facing Child Seat Features Vehicle Compatibility Vehicle Safety BeltsCannot be used. See diagram below Vehicle Seating PositionsLatch Long Route Installation for Children 22 40 lbsVehicle Latch anchor limit Lap-Shoulder Belt Long Route To the front of the child seat shell Lap Belt Long RouteShort route configuration Fig. a Installation for Children 40 80 lbsLatch Short Route Near the vehicle buckle Fig. CPages 26 Reach through the belt slots to access the loop endsLatch connector strap Fig. G Attach the Versa-Tetherhook to the vehicle’s designatedSeat Fig. B Lap-Shoulder Belt Short RouteSeat Fig. C Lap Belt Short Route26 27.D Versa-Tether Using the Versa-TetherBelt Routing with the Recline Bar Using the Chest ClipUsing the Recline Bar Using Child Seat FeaturesUnfasten the buckle by pressing down on Securing Your ChildMiddle button Move the harness straps to the side Adjusting Buckle Position Harness Height AdjustmentCover Removal Care and MaintenanceLubricate Use solvents Use soap or household detergents Front of the child seatUnfastening until a Positive Heard after inserting the second buckleLimited ONE-YEAR Warranty Warranty