Britax Regent Belt Routing with the Recline Bar, Using the Chest Clip, Using the Recline Bar

Page 16

Using the Recline Bar

s

The recline bar must be installed before using this

 

 

restraint.

 

1

Insert the recline bar into the holes in lower

 

 

rear of child seat prior to installation in vehicle

 

 

(Fig. A).

 

2

Use a rubber mallet to tap the recline bar

A

 

ends into holes (Fig. A).

sDo not strike the center of the recline bar near the label as this may bend the recline bar.

3Ensure that the bottom of the child seat shell is in full contact with the vehicle seat and the recline bar is resting against the vehicle seat

back (Fig. B).

B

 

Belt Routing with the Recline Bar

The recline bar is provided to improve stability of the child seat. Proper installation is key to ensuring the best performance of the child seat.

Long Route Installation

When using the long route installation, the C LATCH strap or vehicle belt strap must pass outside of the recline bar. (Fig. C)

Short Route Installation

 

When using the short route installation, the

 

LATCH strap or vehicle belt strap must pass

D

through the inside of the recline bar. (Fig. D)

EXCEPTION: When using the lap-shoulder belt

 

however, the strap must pass on the outside of the recline bar.

Using Child Seat Features

Using the Chest Clip

Open the chest clip by squeezing the middle tabs, while pulling the two pieces apart (Fig. A). IMPORTANT: The correct height for the chest clip

is at the middle of the chest, level with the armpit.

A

Using the Buckle

 

Fastening the Buckle

1 Hold the buckle with one hand. 2 Use your other hand to insert one tongue at

a time into the buckle. Proper connection is confirmed with a positive click, after inserting the second buckle tongue (Fig. B).

Releasing the Buckle

B

1Hold the buckle with one hand.

2Use thumb to press release button to eject the tongues from buckle (Fig. B).

NOTE: Periodically clean the buckle to ensure proper operation. See page 37.

28

29

Image 16
Contents Page Table of Contents Never route the vehicle belt over the child Certification Safety InformationRegistration Forward-Facing Child Seat Features Vehicle Safety Belts Cannot be used. See diagram belowVehicle Seating Positions Vehicle CompatibilityLatch Long Route Installation for Children 22 40 lbsVehicle Latch anchor limit Lap-Shoulder Belt Long Route Lap Belt Long Route To the front of the child seat shellInstallation for Children 40 80 lbs Latch Short RouteNear the vehicle buckle Fig. C Short route configuration Fig. aReach through the belt slots to access the loop ends Latch connector strap Fig. GAttach the Versa-Tetherhook to the vehicle’s designated Pages 26Lap-Shoulder Belt Short Route Seat Fig. BSeat Fig. C Lap Belt Short Route26 27.D Using the Versa-Tether Versa-TetherUsing the Chest Clip Using the Recline BarUsing Child Seat Features Belt Routing with the Recline BarUnfasten the buckle by pressing down on Securing Your ChildMiddle button Move the harness straps to the side Harness Height Adjustment Adjusting Buckle PositionCare and Maintenance Cover RemovalFront of the child seat Unfastening until a PositiveHeard after inserting the second buckle Lubricate Use solvents Use soap or household detergentsWarranty Limited ONE-YEAR Warranty