Britax 70 manual Loosen the harness

Page 36

Rear-Facing Installation

1Loosen the harness.

a Lift harness adjuster lever

b Pull both harness straps forward

2Remove the body pillow, unbuckle the harness, and remove the belly pad.

3Pull the head restraint cover up, then pull the seat cover forward while pulling the buckle through to access the rear-facing belt path.

IMPORTANT: Ensure buckle is in inner slot and lying away from the belt path.

4Open the blue lock-off closest to where the vehicle belt will be buckled.

aOpen the locking tab b Open the clamp

5Route the vehicle belt through the rear-facing belt slots, then buckle. Ensure the vehicle belt is not twisted.

6Push down into the middle of the child seating area with moderate force while removing all slack from the bottom (lap) part of the vehicle belt and close the lock-off.

aClose the clamp over the vehicle belt

b Slide your palm or thumb along the locking tab until a click is heard (see page 19)

7Push the child seat down while pulling the top (shoulder) part of the belt between the belt slots to remove any remaining slack

1b

1a

4b

4a

LOCKING

TAB

CLAMP

5

7

34

through the lock-off.

Image 36

Contents BoulevardTM Page Table of Contents Secure the top anchorage strap provided with this child seat Section Title Important Notes Certification RegistrationImportant Child Seat Usage Information Rear-Facing 5 40 lbs 2.3 18.1 kgForward-Facing Harness Height Compatible Vehicle Seat Belts Lap-Shoulder 3-Point Belt Has a latch plate that locks the vehicle belt Lap Belt Tightens by feeding the belt webbing back into the retractor Incompatible Vehicle Seat Belts Vehicle Seating Positions Child Seat Features Rear-Facing Belt Slot Base Harness Height Adjustment Loosen the harnessAdjusting Buckle Position Using the Chest Clip Fastening the Buckle Releasing the BuckleUsing the Lock-Offs To Open To CloseInfant Body Pillow Recline Positions Rear-FacingForward-Facing Acceptable overhangUnacceptable overhangUsing Lower Anchors and Tethers for Children Latch Top Using the Versa-Tether Rear-Facing Tether Connector Strap To remove the Versa-Tether from the carry clip Shows a tether acceptable for use Latch Installation Before You Begin Install with Latch as shown above Rear-Facing Installation Checklist Lap-Shoulder Belt Installation Before You Begin Install with lap-shoulder belt as shown above Loosen the harness Replace the cover and the belly pad Lap Belt Installation Before You Begin Install with lap belt as shown above Replace the cover and belly pad Checklist Check that your vehicle has lower anchors Install with Latch as shown above Forward-Facing Installation Check Versa-TetherTop Tether attachment Lap-Shoulder Belt Installation Before You Begin Install with lap-shoulder belt as shown above Open the locking tab Open the clamp Checklist Lap Belt Installation Before You Begin Install with lap belt as shown above Loosen the harness Checklist Rear-Facing Installation Forward-Facing InstallationSecuring Your Child Position the harness straps around the child Fasten the harness buckle Loosen the harness Care and Maintenance Care and Maintenance Cleaning the Cover Cleaning the HarnessCleaning the Shell Cover Replacement Replace the belly pad Cleaning the Buckle Remove the BuckleTo Clean Re-thread the Buckle Troubleshooting Problem The harness cannot be adjusted to its full heightLimited ONE-YEAR Warranty Page Britax Child Safety, Inc

Related manuals

Manual 70 pages 8.92 Kb