Britax 70 manual Important Child Seat Usage Information, Rear-Facing 5 40 lbs 2.3 18.1 kg

Page 8

Safety Information

Important Child Seat Usage Information

All infants must ride rear-facing at least until they have reached 1 year of age and weigh 20 lbs (9.1 kg).

An infant positioning insert may be necessary for small infants to achieve a snug fit if the child is under 12 lbs and the lowest harness slots fall above the infants shoulders. The Infant positioning insert is sold separately at select retailers and on www.britaxusa.com.

Britax advises that parents strongly consider the following when using this child seat.

Children should be secured with a harness system until they exceed the weight or height limits specified.

Britax recommends that children ride rear-facing to the highest weight or height specified.

WARNING! REAR-FACINGuse of this child seat is ONLY for children who meet ALL of the requirements below. If the child cannot be secured within these requirements because they are too small, use of the infant positioning insert or selection of a different child seat (such as an infant car seat) may be required. If the child cannot be secured within these requirements because the child is too large, review the forward-facing guidelines on page 7.

Rear-Facing: 5 – 40 lbs (2.3 – 18.1 kg)

Use rear-facing with children:

1 2 .

• who weigh between 5 and 40 lbs (2.3

– 18.1 kg) and

 

• when the top of the child’s head is at

 

least 1 in. (2.5 cm) below the top of the

 

child seat shell (Fig. A) and

 

• when the harness straps are at or slightly

A Rear-Facing

below the child’s shoulders (Fig. A).

 

IMPORTANT: See Harness Height Adjustment on page 16.

6

Image 8
Contents BoulevardTM Page Table of Contents Secure the top anchorage strap provided with this child seat Section Title Important Notes Certification RegistrationImportant Child Seat Usage Information Rear-Facing 5 40 lbs 2.3 18.1 kgForward-Facing Harness Height Compatible Vehicle Seat Belts Lap-Shoulder 3-Point Belt Has a latch plate that locks the vehicle belt Lap Belt Tightens by feeding the belt webbing back into the retractor Incompatible Vehicle Seat Belts Vehicle Seating Positions Child Seat Features Rear-Facing Belt Slot Base Harness Height Adjustment Loosen the harnessAdjusting Buckle Position Using the Chest Clip Fastening the Buckle Releasing the BuckleInfant Body Pillow Using the Lock-OffsTo Open To Close Recline Positions Rear-FacingForward-Facing Acceptable overhangUnacceptable overhangUsing Lower Anchors and Tethers for Children Latch Top Using the Versa-Tether Rear-Facing Tether Connector Strap To remove the Versa-Tether from the carry clip Shows a tether acceptable for use Latch Installation Before You Begin Install with Latch as shown above Rear-Facing Installation Checklist Lap-Shoulder Belt Installation Before You Begin Install with lap-shoulder belt as shown above Loosen the harness Replace the cover and the belly pad Lap Belt Installation Before You Begin Install with lap belt as shown above Replace the cover and belly pad Checklist Check that your vehicle has lower anchors Install with Latch as shown above Forward-Facing Installation Check Versa-TetherTop Tether attachment Lap-Shoulder Belt Installation Before You Begin Install with lap-shoulder belt as shown above Open the locking tab Open the clamp Checklist Lap Belt Installation Before You Begin Install with lap belt as shown above Loosen the harness Checklist Rear-Facing Installation Forward-Facing InstallationSecuring Your Child Position the harness straps around the child Fasten the harness buckle Loosen the harness Care and Maintenance Care and Maintenance Cleaning the Shell Cleaning the CoverCleaning the Harness Cover Replacement Replace the belly pad Cleaning the Buckle Remove the BuckleTo Clean Re-thread the Buckle Troubleshooting Problem The harness cannot be adjusted to its full heightLimited ONE-YEAR Warranty Page Britax Child Safety, Inc
Related manuals
Manual 70 pages 8.92 Kb