Britax 70 manual Install with Latch as shown above

Page 43

Forward-Facing Installation

Install with LATCH as shown above.

WARNING!

Your child seat may not perform as intended if the base of the child seat is not flat on the vehicle seat.

This child seat must not be used forward-facing for children less than one year of age OR who weigh less than 20 lbs (9.1 kg).

Some vehicle head restraints may obstruct the harness adjuster from reaching the highest position. If this is the case, you may need to raise or

remove the vehicle head restraint. DO NOT force the child seat head restraint past the vehicle head restraint. Doing so could cause the child seat not to perform as intended.

41

Image 43
Contents BoulevardTM Page Table of Contents Secure the top anchorage strap provided with this child seat Section Title Important Notes Registration CertificationRear-Facing 5 40 lbs 2.3 18.1 kg Important Child Seat Usage InformationForward-Facing Harness Height Compatible Vehicle Seat Belts Lap-Shoulder 3-Point Belt Has a latch plate that locks the vehicle belt Lap Belt Tightens by feeding the belt webbing back into the retractor Incompatible Vehicle Seat Belts Vehicle Seating Positions Child Seat Features Rear-Facing Belt Slot Base Loosen the harness Harness Height AdjustmentAdjusting Buckle Position Fastening the Buckle Releasing the Buckle Using the Chest ClipTo Open To Close Using the Lock-OffsInfant Body Pillow Rear-Facing Recline PositionsAcceptable overhangUnacceptable overhang Forward-FacingUsing Lower Anchors and Tethers for Children Latch Top Using the Versa-Tether Rear-Facing Tether Connector Strap To remove the Versa-Tether from the carry clip Shows a tether acceptable for use Latch Installation Before You Begin Install with Latch as shown above Rear-Facing Installation Checklist Lap-Shoulder Belt Installation Before You Begin Install with lap-shoulder belt as shown above Loosen the harness Replace the cover and the belly pad Lap Belt Installation Before You Begin Install with lap belt as shown above Replace the cover and belly pad Checklist Check that your vehicle has lower anchors Install with Latch as shown above Forward-Facing Installation Check Versa-TetherTop Tether attachment Lap-Shoulder Belt Installation Before You Begin Install with lap-shoulder belt as shown above Open the locking tab Open the clamp Checklist Lap Belt Installation Before You Begin Install with lap belt as shown above Loosen the harness Checklist Forward-Facing Installation Rear-Facing InstallationSecuring Your Child Position the harness straps around the child Fasten the harness buckle Loosen the harness Care and Maintenance Care and Maintenance Cleaning the Harness Cleaning the CoverCleaning the Shell Cover Replacement Replace the belly pad Remove the Buckle Cleaning the BuckleTo Clean Re-thread the Buckle Problem The harness cannot be adjusted to its full height TroubleshootingLimited ONE-YEAR Warranty Page Britax Child Safety, Inc
Related manuals
Manual 70 pages 8.92 Kb