ASSEMBLY and USE continued
5 Insert one side of floorboard | |
under Pocket on side of |
|
bassinet. |
|
Pockets
6 Pull Pocket down over floorboard to hold floorboard in place.
Repeat steps 5 and 6 for other side of floorboard.
7Push down on center of floorboard to flatten.
Bassinet
Storage Pouch
8 Slide opening in infant canopy over hooks making sure canopy goes completely over plastic.
NOTE: Infant canopy attaches to end of bassinet opposite storage pouch.
9 Fasten lower snaps on infant canopy ends to lower snaps on bassinet.
10To adjust infant canopy, rotate canopy frame forward or backward to desired location.
To hold canopy in full forward position, fasten upper snaps on infant canopy to upper snaps on bassinet.
CAUTION: DO NOT place supplies weighing more than 2.3 kg (5 lbs.) in bassinet storage pouch.
Bassinet assembly is now complete.
•Bassinet can be used with or without changer.
•Bassinet can be used with or without Playard.
•Bassinet can be used with or without infant canopy.
To use bassinet with Playard:
1Place bassinet in Playard so that hooks go over long rails with
NOTE:
2Secure bassinet to Playard:
• Pass Attachment Strap through opening in corner of side panel of Playard.
• Fasten strap to outside of Playard.
Repeat for other strap.
Attachment
Strap
Bassinet is now ready for use with Playard.
To use bassinet without Playard:
WARNING
Prevent falls and suffocation:
•Use only on a surface that is flat, level and stable.
•Keep bassinet away from surface edges.
1Set bassinet on flat and stable surface that will keep floorboard level so child will not roll into corner or side of bassinet resulting in breathing difficulties.
2Keep at least 30.5 cm (12 inches) away from surface edges and stay within reach of child. Child’s wiggling and rocking may cause bassinet to move and possibly fall off surfaces.
5