OPERATIONS and ADJUSTMENTS
1HarnessStraps(fig.a):
•To tighten: Pull belt tab.
•To loosen: Lift and hold metal release bar while pulling shoulder harness straps.
2HarnessTie:
•To open: Press tab and pull apart.
•To close: Snap halves together. Make sure harness tie is locked by pulling out on each half.
3Buckle:
MUST be in opening closest to but not under child.
•To buckle: Insert both tongues into buckle. Pull up on tongues to be sure they are locked.
•To unbuckle: Press red button and pull tongues out of buckle.
OverheadShieldModels
•To buckle: Push tongue into opening. Pull up on tongue to be sure it is locked.
•To unbuckle: Press red button, pull tongue out of opening and lift shield
18over top of car seat.
4
5
6
Recline/UprightPositions(fig. b):
Upright Position: Rotate stand out and push into car seat (fig. b).
Recline Position: Pull stand out and rotate into car seat.
Harness straps MUST move freely. Make sure harness straps are not pinched by recline stand.
•From bottom of car seat, pull crotch strap clip out and remove clip from crotch strap loop.
•From top of car seat, pull crotch strap out and thread through desired slot. Make sure red button is facing away from child.
•From bottom of car seat,
OverheadShieldAdjustment(fig.d):
•To adjust: Press button down and slide shield to desired position closest to child. Release button to lock shield into one of multiple positions.
NOTE: Shield does not need to contact child when in closest position; harness system restrains child.