Graco PD163434A owner manual Placing Child in Child Restraint, Safety Check

Page 46

18.0 SECURING CHILD IN CHILD RESTRAINT

18.1 Placing Child in Child Restraint

1.Place child in child restraint A with child’s back flat against back of child restraint. Avoid bulky clothing.

2.Place harness straps over child’s shoulders and insert tongue(s) into buckle B.

3.Pull up on tongue(s) to be sure they are locked.

4.Close chest clip C:

Position chest clip at arm pit level.

5.Pull on harness adjustment strap to tighten straps as shown D. A snug strap should not allow any slack. It lies in a relatively straight line without sagging. It does not press on the child’s flesh or push the child’s body into an unnatural position.

6.SAFETY CHECK :

a)MAKE SURE the top of the child’s head is at least 1” (2.54 cm) below the top of the infant restraint.

b)CHECK that harness straps are not twisted.

c)CHECK that the harness is snug. You should NOT be able to pinch E the harness if it is snug. A snug strap should not allow any slack. It lies in a relatively straight line without sagging. It does not press on the child’s flesh or push the child’s body into an unnatural position.

7.A rolled towel can be used on each side to support small children F. Be sure towels do not interfere with harness system. Towels should NOT be placed under child.

46

Image 46
Contents Smart SeatTM Child RestraintTable of Contents REAR-FACING Page Properly Routing the Vehicle Seat Belt or Latch Page Never Attach two Latch connectors Page Page Register Your Child Restraint Model Number Manufactured Purchase DateChild Restraint Useful Life For Recall Information If You Need HelpCertification Second Hand Child RestraintAttaching Latch Storage Compartment Attaching CupholderClick Features Page Base Page Height & Weight Limits Preterm or Low Birthweight Infants Rear-facing with base 5 to 40 lbs .2-18.1 KgForward-facing with base 20 to 65 lbs to 29.5 kg Booster Without base 30 to 100 lbs .6 to 45 kg Vehicle Seat Location Requirements Serious Injury or DEATH. Some seatingVehicle Seat Belt Requirements Safe Vehicle Seat Belt SystemsWith or Without Built-in Harness For Built-in Harness OnlyCombination Lap/Shoulder Belt with Combination Lap/Shoulder Belt with Retractor Unsafe Vehicle Belt SystemsLap Belts with Emergency Locking Retractor ELR Passive Restraint Lap or Shoulder Belt Mounted on DoorPassive Restraint Lap Belt with Motorized Shoulder BeltWhat is LATCH? LatchVehicle Lower Anchor Points Seat Crease Vehicle Top Tether Latch System REAR-FACINGFORWARD-FACINGInstalling Base Using Vehicle Seat Belt Belt VehicleLap Belt Installing Base Using Latch Belt must lay flat and not be twistedPage REAR-FACING Installation Locked FORWARD-FACING Installation Tether Tether USE Tether Storage Latch StorageBuckle Harness StrapsChest Clip Crotch StrapBottom Body Support on certain models To prevent ejection in sudden stop or crashHarness Covers & Crotch Strap Cover on certain models To prevent serious head injury in sudden stop or crashUsing Recline FORWARD-FACING Safety Check Placing Child in Child RestraintChest Clip Buckle Check Harness System To prevent serious injury or deathAdjusting Head Support/ Harness Straps Refer to page 48 for harness strap Placement.49Booster Installation D19.1 Storing HarnessBottom Using Child Restraint in Booster Mode Page Head Support in Booster Mode , p Securing Child in Booster Seat and VehicleArmrest Shoulder Belt Lap belt Adjusting Head Support in Booster Mode Adjusting Armrest Additional InformationRemoving Seat Cover Care and Maintenance Airplane UseWarranty,and Replacement Parts