FORWARD-FACING INSTALLATION WITH LATCH
1Adjust child restraint to Upright position (fig. a). Flip recline feet out for forward facing use.
Make sure Rear Facing LATCH belt is stored. (see fig. b, pg. 37)
2Place
For ease of installation, extend LATCH belt to its maximum length.
3Hook connectors to vehicle lower anchors (fig. b). Belt must lay flat and not be twisted. Pull connectors to be sure they are securely attached (fig. c).
4Slide child restraint back until the restraint is in contact with the vehicle seat back.
5Press down firmly in center of child restraint to compress vehicle seat cushion while tightening LATCH belt by pulling adjustment belt (fig. d).
6Pull front to back and left to right at belt path to check for secure installation (fig. e).
7Check that the lower anchor belt stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service.
8Attach tether strap hook (A) to anchor hardware (B) and tighten adjustment belt to remove any slack (fig. f).
Belt must lay flat and not be twisted.
Periodically check that child restraint is securely installed; adjust if necessary.
To remove LATCH, (see “Removing LATCH from Vehicle Anchor Points”, p. 36).