FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS
WARNING
LATCH belts MUST be stored when using vehicle seat belt to install child restraint.
1Store Rear Facing and Forward Facing LATCH belt as shown. (fig. a).
Adjust car seat to upright position
Flip recline feet out for forward facing use (fig. b).
2Place
seat back.
3Thread vehicle seat belt through openings and buckle belt (fig. c).
4Press down firmly in center of child restraint to compress vehicle seat
cushion while tightening vehicle seat belt (fig. d).
5Pull front to back and left to right at belt path to check for secure installation (fig. e). Vehicle lap belt
MUST stay tight. If not secure, see “Vehicle Seat Belts” pg. 38.
6Attach tether strap hook (A) to anchor hardware (B) and tighten adjustment belt to remove any slack (fig. f) . If vehicle does not have anchor points to attach tether hook, tether hook should be stored, see “Tether Storage”, page 47. Belt must lay flat and not be twisted.
Periodically check that child restraint is securely installed; adjust if necessary.
To remove LATCH, (see “Removing LATCH
from Vehicle Anchor Points”, p. 36).