PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing, call Customer Service
at
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
No tools required for assembly.
FrameSeat
Retainer | Cap |
Rear wheel (2) (2, 1 extra) | (2, 1 extra) |
Rear axle assembly | Front wheel |
assembly (2) |
To Assemble Front Wheels |
| T | |
To prevent |
| Pl | |
| of | ||
serious injury or death | End cap | ||
ax | |||
from choking, remove and |
| ||
|
| ||
IMMEDIATELY discard plastic |
|
| |
end caps on the front leg pins. |
|
|
Step 1.
Remove and discard the plastic end caps on the front leg
pins. Line up pin with a wheel assembly as shown.
Plastic snap inside wheel mount must be away from pin. Push wheel assembly onto pin until it snaps into place.
Step 2.
Repeat for other wheel assembly.
NOTE: Pull firmly on each wheel assembly to be sure the wheel assemblies are securely attached.
To Assemble Rear Axle
Boot |
|
(on certain models) | Canopy |
To Unpack Stroller
Step 1.
Flatten stroller carton to protect floor. Slide seat out from frame and set it aside.
Rear legs
Step 1.
Turn stroller over as pictured above.
Brake levers | B |
point toward |
|
you |
|
T
St
Se
St
Lin fra Se ea
Step 2.
Open stroller frame | Locking | |
latch | ||
on carton by lifting | ||
| ||
handle until locking |
| |
latches on both sides |
| |
are locked as shown. |
|
Step 2. |
| |
Position rear axle assembly as shown. |
| |
Step 3. |
| |
Start both brackets onto leg tubes at the same time. |
| |
Step 4. | St | |
Push both brackets on until plastic tabs snap into the slots | ||
To | ||
on the legs. | ||
or | ||
| ||
Step 5. | on | |
| ||
Pull firmly on each bracket to be sure the brackets are |
| |
securely attached. | w | |
6 |
|