ap
To Assemble Rear Wheels
Place one rear wheel, red retainer, and white cap on one end of rear axle in order as shown below. Push red retainer onto axle BEFORE attaching white cap. Repeat on other side.
To Adjust Back
To raise or recline seat back, pull up the plastic handle at back of seat and adjust seat back to desired position.
Spokes
toward
inside
Rear
axle
Snap red retainer into axle
groove. Then snap cap
over red retainer as shown.
Wheel
Cap (white) Attach AFTER retainer is on axle
Retainer (red) Wide end toward wheel
Seat back can adjust to five different positions.
To Assemble Canopy
Step 1.
Position canopy over back of stroller frame as shown. Align the ends of the canopy mounts with the openings in the seat covering. Push the canopy mounts into the slots until they snap in place.
rs
d
Be sure cap is snapped securely over red retainer.
To Attach Seat
Step 1.
Set the stroller frame upright.
Step 2.
Line up notches on sides of seat with plastic brackets on frame. Lower seat onto frame until it snaps into brackets. Seat can be installed facing either direction. Pull up on each side of seat to be sure it is securely attached.
Step 2.
To remove canopy, push in the button hidden under the padding directly under one canopy mount, and
pull the canopy mount out of the slot. Repeat on other side.
Button under
padding below canopy mount
OR
Step 3.
To remove seat to reverse position or for cleaning, squeeze the levers on both sides of seat and lift.
DO NOT lift, reverse or carry the seat while child is in the seat.
7
To Adjust Canopy
Push or pull canopy to desired position.
8