To Use Boot (on certain models)
Step 1.
Put seat back into any position except fully reclined. (For fully
wreclined carriage position, see
. | below.) Set footrest at seat |
| height and snap arm bar into the |
| extended position. CHECK that |
| footrest is secure at seat height |
| by pressing down on it. If not, |
| adjust metal bar under footrest. |
| Place boot under the footrest. |
| Slide it over footrest and arm bar |
| as shown. |
Step 2.
Fasten snaps at top and bottom corners of the boot to padding at each side.
If seat is being used in fully reclined carriage position, close off leg opening as described in “To Adjust Footrest” before placing boot on stroller.
Step 3.
Unhook the small elastic loops from the two plastic tabs found under the footrest.
Step 4.
Turn seat right side up. Put footrest down. Remove arm bar. (See “To Adjust Arm Bar” instructions.)
Step 5.
Unbuckle the seat belt. Carefully remove covering from seat frame. Please note to:
!Pull crotch strap out of slot in covering.
!Pull webbing strap and “D” rings out of slots in the
!seat frame.
Step 6.
Crotch strap may also be removed for washing. Under the seat frame, push the plastic crotch strap retainer through the slot in the frame to remove it.
To Remove Seat Covering
To Reattach Seat Covering
To reattach the seat covering, reverse the previous steps.
Seat covering may be removed for washing.
Step 1.
Slide back part of covering over rear of seat frame. Be
sure back part of covering slides behind, not over, the side panels of the seat.
Fit covering behind
side panels
Snaps
Step 1.
Turn seat upside down. Unsnap VELCRO® at sides of the seat to release side flaps. Unsnap two snaps at bottom of seat back and release elastic straps from bar.
Step 2.
Unfasten webbing strap from “D” rings under the seat.
11
Step 2.
Replace all straps:
!Push webbing strap and
! “D” rings through slots in ! the seat frame as shown.
! If needed, reattach crotch ! strap by pushing lower
!plastic crotch strap retainer
! through slot in seat frame. ! Push crotch strap through
!slot in seat covering.
Step 3.
Fit sides of covering over side panels of seat. Push covering down into seat.
12