28
!A lap/shoulder combination belt with a latchplate that can slide freely along the belt Ê requires the locking clip, unless your vehicle’s
seat belt can be converted in another way, described in your vehicle |
| |
owner’s manual. See your vehicle owner’s manual | Ê | |
to find out if your seat belt can be converted to | ||
| ||
prevent movement of the lap portion of the belt. |
| |
Otherwise, the locking clip MUST be used. |
|
To install the locking clip:
a. Tighten the buckled seat belt by pushing down hard on the car bed and pulling hard on the shoulder belt.
b. While continuing to push down on the car bed, let go of the shoulder strap and pinch the two straps together just behind the buckle tongue.
c. While still pinching the straps together, unbuckle the seat belt. Do not allow the straps to slip.
d. Connect the lap belt to the shoulder belt by placing the locking clip on the belts about
½ inch from the buckle tongue as shown Ë.
e.
Ë
½
inch
f. Repeat this procedure if the lap belt is loose or lengthens when pulled.