Sound &
Movement 
NOTE: Make Sure your Sensor Pad is set up before proceeding with this section. If you haven't set up your Sensor Pad please go to Pg.8 for instructions on how to properly set up the Sensor Pad.
1
Sensitivity 
Sensor Pad 
•Sound & Movement: You will be able to hear your baby's sounds, see sound lights, and hear a “Tic” sound with every
movement your baby makes. If no movement is detected, the “Tic” will stop and after 20 seconds the alarm will sound.
Sound & |
|
Movement | Sound |
| Only |
| Tic Off |
Nursery
Unit
Model #AC201
Switch the Nursery Unit to the "Sound & Movement" function. Turn the Parents' Unit ON by selecting either channel "A" or "B". Make sure it is set to the same channel as the Nursery Unit. The Movement Indicator Light on the Nursery Unit will flash red, green, and then emit a single "Tic" sound. Gently pat your hand on the mattress. The green Movement Indicator Light will continue to flash with every movement. The Nursery Unit will also tick with every movement.
Remove your hand from the mattress. Due to no movement, the ticking will stop, the Movement Indicator Light will stop flashing, and a
Tic Off
You can also test for movement with the Nursery Unit set to the “Tic Off” position. In this case, you will not hear a constant ticking when you touch the mattress. When you remove your hand from the mattress the Movement Indicator Light will stop flashing, a
To turn off the alarm, turn the Nursery Unit off or pat your hand lightly on the mattress so the Sensor Pad will redetect movement. The red Alarm Indicator Light on the Nursery Unit will continue to flash for one minute and it will then revert to green.
If the alarm does not sound when you are not touching the mattress, the Sensor Pad may be detecting a continuous vibration from another source from inside and/or outside your baby's room. Common sources of this interference are crib mobiles, fans, washing machines, or even loud music. Therefore, it is very important to make sure all vibration sources are eliminated before using the monitor. Place the crib near a solid supporting
wall and away from strong air currents. Do not use crib mobiles or accessories that may cause vibrations. Avoid contact with the crib when the monitor is in use. If you find the alarm will still not sound when you are not touching the mattress or crib, the monitor is on, and you have removed all external sources of vibration, the sensitivity level may need to be decreased. Please refer to the Movement Sensitivity Adjustment section on page 11.
10