Setting
Up Your Monitor 
SENSOR PAD (See figs. 1 and 2)
Place the Sensor Pad under the center of the crib mattress with the blue side facing up. Do not place any loose bedding or linen between the crib mattress and the Sensor Pad. The Sensor Pad must rest on a flat, firm surface. If your crib has a spring or slat base, place a piece of Masonite board under the Sensor Pad. This support must measure at least 13 inches long on all four sides and 1/4 inch thick. (You may order a Masonite board directly from us.
Call Graco at
CAUTION: To avoid potential strangulation accidents resulting from loose cords or wires in the crib, make sure the Sensor Pad cord passes underneath the mattress entirely. After positioning the Sensor Pad under the mattress, bring the cord to the corner of the crib and secure it to the top and bottom of the leg of the crib, or wind it around the leg
(see fig. 1).
fig. 1
Figure 1
PLACEMENT OF SENSOR PAD CORD
CORRECT | INCORRECT | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Sensor Pad |
|
|
| Sensor Pad | ||||||
|
|
| ||||||||
fig. 2
POSITION OF SENSOR PAD UNDER MATTRESS (Top Down View of Crib)
| CORRECT |
|
|
| INCORRECT |
|
|
| INCORRECT |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Sensor Pad Centered Turquoise Side Up | Sensor Pad Off Center | Sensor Pad Turquoise Side Down |
Movement Sensitivity Control.
IMPORTANT: Only use the AC adapters included with your monitor. Do not use these adapters with any other equipment. Movement Sensitivity Control. The movement sensitivity control is on the back of the Nursery Unit. The level has been preset to 2.5 (see fig. 3). Do not adjust this unless you receive false alarms. Refer to the Movement Sensitivity Adjustment section on Pg. 11 for more information. It is extremely important to follow our instructions for setting the sensitivity level.
fig. 3
Now plug the Sensor Pad cord into the jack on the back of the Nursery Unit marked “Sensor Pad.” Turn the Nursery Unit on using the switch on the left. The green Power Indicator will light up.
8