Graco ISPD026BB, AC2012P, 1750296 owner manual Tips For Using Your Monitor

Page 12

Tips ForUsing Your Monitor

When the monitor is in use, do not use a crib mobile or other crib accessories that may produce vibrations. Other sources of vibrations may include fans, washing machines, loud music, etc. These sources of vibration may interfere with the performance of your Angelcare® monitor and the alarm will not sound if it continues to detect any movement. Be sure all vibration sources are eliminated before using the monitor.

There are several reasons you may experience false alarms. The most common reason is the Nursery Unit has not been turned off after you have removed your baby from the crib. Another reason is the Sensor Pad has not been placed under the mattress properly. Be sure the Sensor Pad is on a flat, hard surface with the blue side facing up. The sensitivity level may also need to be adjusted. Refer to the Movement Sensitivity Adjustment section on page 11.

Your monitor can be used in any crib that is stationary and designed to safely hold a baby. If your crib has a spring or slat base you will need to place a piece of Masonite board under the pad. This support must be at least 13 inches long on all four sides and 1/4 inch thick. Only use your Angelcare® monitor in a stationary sleeping environment such as a crib where the Sensor Pad can rest on a hard, flat surface.

Please note the difference between the Low Battery Indicator and the Alarm Indicator on the Nursery Unit. The Low Battery Indicator is a rapid ticking sound and the Low Battery Indicator Light turns orange. The Alarm Indicator is a loud beeping sound and the red Alarm Indicator Light flashes.

When unplugging the AC adapter from each unit, be sure the unit is switched to the off position. If it isn't, the unit will revert to battery mode if batteries are installed.

You can use rechargeable batteries, however, a rechargeable battery cannot be recharged by plugging in the AC adapter. Remove batteries from the unit to recharge.

The range of this monitor is approximately 200 feet. However, the range will vary depending on the surroundings. Test the range before use. NOTE: This monitor is not equipped with an out-of-range indicator. No sound will be received if the Nursery Unit and Parents' Unit are too far apart.

12

Image 12
Contents Movement Sensor With Sound Monitor Do not Open the Nursery UNIT, Parent Unit or Adapters Page Page Features Parent UnitNursery Unit Installing Batteries in Parent Unit Installing Batteries in Nursery Unit Setting Up Your Monitor Movement Sensitivity ControlActivating Units Sound OnlySound & Movement Tic OffSpecial Features Movement Sensitivity AdjustmentTips For Using Your Monitor Testing Your Monitor Care and Maintenance TroubleshootingProblem Possible Cause Solution Problem Possible Cause Solution Page Page Page Replacement Parts Warranty Information USA Detector de movimiento con monitor de sonido Page Page Advertencia Características Unidad para padresCómo instalar las pilas en la unidad para padres Cómo instalar las pilas en la unidad del dormitorio Instalación de su monitor Control de la sensibilidad del movimientoActivación de las unidades Sonido solamenteSonido y movimiento Tic apagadoCaracterísticas especiales Ajuste de la sensibilidad del movimientoSugerencias para el uso del monitor Cómo probar su monitor Atención y mantenimiento Solución de desperfectosProblema Causa posible Solución Problema Causa posible Solución Notas Notas Notas Información sobre la garantía y las piezas De repuesto EE.UU