Graco 1750296, ISPD026BB, AC2012P owner manual Care and Maintenance, Troubleshooting

Care and Maintenance

Disconnect all units and remove all batteries before cleaning. Clean the exterior surface of the units with a soft dry or slightly damp cloth. Do not spray with cleaning products or solvents.

Do not submerge in water or any other liquid.

During long periods of non-use, remove all batteries from their compartments and unplug the AC adapters.

Troubleshooting

Problem

False alarms

Possible Cause	Solution
Baby was removed from crib	Turn the Nursery Unit off.
and the Nursery Unit was not
switched off.
The turquoise side of the	Make sure the turquoise side is
	facing up.
Sensor Pad is not facing up.
The Sensor Pad is not detecting	The sensitivity level may need
	to be increased.
your baby’s movements	Refer to the Movement
because the sensitivity level is	Sensitivity Adjustment section
too low.	on Pg. 11.
Sensor Pad is not in full contact	Make sure there is no thick
with the crib mattress or is not
resting on a flat, firm surface.	bedding between the mattress
	and the Sensor Pad. The
	Sensor Pad must rest on a firm
	surface. If the crib has a spring
	or slat base, place a piece of
	Masonite board measuring at
	least 13” on all four sides and
	¼” thick.
Baby has moved far away from	Make sure the Sensor Pad is
the Sensor Pad.
	positioned correctly in the crib.
	Sensitivity level may need to be
	adjusted.
	Refer to the Movement
	Sensitivity Adjustment section
	on Pg. 11.

14