Graco 9748 To Set Up Your Pack ’N Play, Avoiding Strangulation Hazards, Care and Maintenance

ard or portable crib. Read and follow the warnings and on the bottom of the Pack ’N Play. The short time you s will help you use your Pack ’N Play properly.

follow these warnings and the assembly s could result in serious injury or death.

length and width, and is less than one inch thick in order to meet safety standards. Using a thicker or a different sized mattress may allow a child’s head to get between mattress and the side of the Pack ’N Play causing suffocation.

! To help prevent suffocation from entrapment,

he	USE ONLY THE MATTRESS PROVIDED BY GRACO.
	Never use additional mattress or padding.
N
	! Never use plastic shipping bags or other plastic film as
	mattress covers not sold and intended for that purpose.
	They can cause suffocation.
	! Do not use a water mattress with the Pack ’N Play.

Avoiding Strangulation Hazards

!Strings and cords can cause strangulation. Keep strings and cords away from child.

p-	! Do not place the Pack ’N Play near a window where
	cords from blinds or drapes can strangle a child.

!Do not hang strings on or over the Pack ’N Play.

!Do not place items with a string around a child’s neck,

esuch as hood strings, pacifier cords, etc.

!Do not attach strings to toys.

eThis product is not intended for commercial use.

CARE AND MAINTENANCE

FROM TIME TO TIME CHECK YOUR PACK ’N PLAY for worn parts, torn material or stitching. Replace or repair the parts as needed. Use only Graco® replace- ment parts.

IF PACK ’N PLAY IS USED AT THE BEACH, you MUST clean sand off your Pack ’N Play, including the feet, before packing it into cover. Sand in top rail lock may damage it.

TO CLEAN PACK ’N PLAY, use only household soap or detergent and warm water. NO BLEACH.

TO WASH CARRY BAG AND FITTED SHEET

(on certain models), machine wash in lukewarm water on delicate cycle and drip-dry. NO BLEACH.

ure to follow these warnings and

s could result in serious injury or death.

Setting up the Pack ’N Play® is easy, but only if you know how.

To Set Up Your Pack ’N Play®

Step 1.

Undo the three VELCRO® straps. Fold VELCRO® straps back onto themselves.

Set mattress aside.

Step 2.

IMPORTANT: Leave center of floor UP until all four top rails are latched.

Grasp the bottom of two of the top rails, and pull up until you hear a “click.”

Be sure top rails	Top rail
have become rigid.

If not, pull up again until they are rigid.

FOR SMOOTH SETUP and takedown, it’s impor- tant to remember one thing: the center of the floor must be at least halfway up when locking OR unlocking rails (see picture below). Therefore:

!When setting up, lock rails BEFORE lowering center.

!When taking down, raise center halfway BEFORE unlocking rails.

Step 3.

Pull up the other two sides until they latch.

NOTE: If top rails do not latch, lift the center of the floor higher. Center of floor must be at least halfway up for the latches to catch properly.

Be sure all top rails are rigid.

Step 4.

Hold one end of the unit up and push the center of the floor down.

3 4