To Attach Seat
Step 1.
On playtray models, remove playtray from activity center tray by unsnapping both side tabs from under tray.
Step 2.
Insert the pegs on the seat back into the four holes located at the rear of the tray.
Underneath the tray,
insert the four screws
into the centers of the 
pegs. Press down on 
the seat back to help the screws connect with pegs. Tighten the
screws securely, but do not
overtighten.
Plastic pegs
Bottom of 
seat back
To Attach Base
Step 1.
Place base on floor with wheels down.
Step 2.
Open tubes of tray assembly as shown until they latch.
Step 3.
Front tube has plastic “T” ends. Tilt tray assembly as shown. Insert one plastic “T” into slot on the inside front of the base. Repeat on opposite side, flexing tube inward if needed to engage the slot.
Nut
Right
bracket
Left | Seat rod | |
inside seat | ||
bracket | ||
tunnel |
Step 4.
Lower rear tube so holes in ends of tube line up with two holes in back of activity center base.
Be sure that plastic “T” pieces remain in their slots.
Bent end seated
in channel
Step 3.
With the tray assembly upside down and its front facing you, pull up on one of the tube ends until the tubes snap into the first height position.
Insert seat rod through hole in left bracket, then through the tunnel of the seat.
Step 4.
Now push the threaded end of the seat rod through the right bracket hole. Turn the bent end of the rod so it fits securely into the left bracket channel. Push it into place.
Place nut on seat rod threads and tighten securely with wrench or pliers.
Step 5.
Insert pin into hole as shown, through tray tube, and out through base hole on the other side.
Press firmly until tab snaps over head of pin. Repeat on other side.
Be sure all parts of tray and base are securely fastened, with “T” pieces in their slots and tabs holding pins firmly.
Push
Tab holds
Head pin of pin
5 |
6