To Assemble the Mix ’N Move® Toy Gym (on certain models)
Before assembling, check that you have all the parts listed below:
Mix ’N Move® toys (styles may vary)
Mounting
post
and cap (2 each)
Bar and beads
Step 1.
To mount beads on bar: flatten ring at one end of bar as shown and push through hole in center of each bead.
Step 2. | Shorter teeth |
Place ring on top of | on bottom |
| |
a mounting post. |
|
Shorter teeth must |
|
be on the bottom, as |
|
shown. Top of mounting |
|
post will be even with top |
|
of ring. Snap cap into place |
|
inside mounting post and turn |
|
it up to one half turn until it |
|
locks in place. Repeat with |
|
the other ring, post and cap. |
|
Step 3.
Mount posts onto front corners of activity center tray as shown until they snap securely into place. Center of bar should curve away from the seat, not toward it.
Step 4.
Insert the two prongs on a toy base into a cap at the notches.
Step 5.
Turn toy base one quarter turn until you feel the toy snap into place. Check that toy is firmly inserted by pulling on the toy.
Toy is removable (turn it the other way with a little pressure) so that you can replace it with other toys when desired (sold
To Attach the Spoiler (on certain models)
Line up the pegs on the bottom of the spoiler with the two holes at the back of the activity center and push the spoiler in until it snaps in place. It will not be removable.
Do not allow spoiler to block seat by inserting it backwards.
Avoid falls and other hazards. Never allow unit to be pushed while child is in product.
11 | 12 |
|
|