DCS DS224 Finalchecklistdoubleandsinglemodels, Customer Care, Double Models Only, DCS Appliances

Models: DS224

1 12
Download 12 pages 63.47 Kb
Page 12
Image 12
STEP 11: FITTING THE TOE KICK TO THE PRODUCT

INSTALLATION INSTRUCTIONS

STEP 11: FITTING THE TOE KICK TO THE PRODUCT

R

(DOUBLE MODELS ONLY)

Toe kick mounting rails

25

26

25Partly open bottom drawer. Position Toe Kick behind door and slide onto the mounting rails on the underside of tub.

26Close bottom drawer, check if flush with adjacent cabinetry. If required open drawer and adjust.

Note: Clearance between Toe Kick and floor must be 12mm minimum.

When Toe Kick is in position, open bottom drawer and gently fasten the Toe Kick screws, on each side.

Important!

DO NOT over tighten screws.Overtightening will damage the plastic mounting detail.

STEP12:FINALCHECKLIST(DOUBLEANDSINGLEMODELS)

Be sure product is level, securely fastened to the cabinetry and opens and closes freely. The DishDrawer® must be free to close with no resistance from the cabinetry.

Be sure the inlet hose to valve connection is tightened a further half turn after seal contact.

Be sure any knock-outs or plugs in drain connection have been drilled out and drain connection has been made.

Turn ON the power and water supply. The DishDrawer® should beep and light up.

Open the drawer(s) and check operation of Wash Program Control Panel and check the sprayarm(s) are in place and free to rotate.

On the Wash Program Control Panel select Rinse and close the drawer(s). Start the program by pressing the Start/Pause button.

After the Rinse program has finished, be sure the machine has run and drained correctly.

Check water supply and drainage connection for leakage.

Repeat for each Drawer.

LEAVE ALL LITERATURE WITH CUSTOMER.

TROUBLE SHOOTING

Excessive water remaining above the filter plate, after the rinse cycle; check for kinked drain hoses or blocked waste connection.

No water supply; check water is connected, ON and there is the specified water pressure.

DishDrawer® does not light up when the tub is opened; be sure power is connected and is switched ON.

Water around water supply and drainage connections - check connections, existing plumbing and hoses for leaks.

If a fault occurs, consult the Fault Code Section of the Use & Care.

If unable to resolve, contact your Customer Care Centre.

STEP 13: CUSTOMER CARE

If you have any questions concerning the installation of this DishDrawer® , please contact DCS Appliances.

FOR THE UNITED STATES OF AMERICA (USA) & CANADA

DCS Appliances

Attention: Consumer Relations 5900 Skylab Road Huntington Beach, CA 92647 Fax us at: (714) 372-7003

email: support@dcsappliances.com

web site: www.dcsappliances.com

PHONE TOLL FREE: (888) 281-5698

12

Page 12
Image 12
DCS DS224 Finalchecklistdoubleandsinglemodels, Customer Care, Double Models Only, Trouble Shooting, DCS Appliances