DCS DS224 Electrical Connection, Refitting The Tub, The product MUST NOT be

INSTALLATION INSTRUCTIONS

STEP 5: ELECTRICAL CONNECTION

14

This view shows the bottom left-hand rear corner with the cover removed

15

R

WARNING!	WARNING!
The product MUST NOT be	If permanently connecting be
plugged in at this stage.	sure the power is isolated.

14Be sure there is a power outlet in reach of the supplied power cord. If there is not a suitable outlet available then have one installed by a qualified electrician.

Do not use an extension cord.

15Alternatively, the DishDrawer® may be permanently connected to a flexible conduit.

Remove the power supply cord. Remove round knock-out for cable clamp. Fit suitable cable clamp for the conduit and terminate the wiring as shown. Terminate the ground wire using the saddle that was used on the existing earth.

WARNING!

This must only be done by a certified person.

STEP 6: REFITTING THE TUB

Drawer Latch

Runner

Latch

Bracket

16

	Tub Clip
17	INCORRECT

Important!

Before refitting the tub, be sure the hoses are not twisted and the latches at the rear of each drawer runner are facing forward.

16To refit the tub, make sure both of the latches at the rear of each drawer runner are facing forward. Ensure hoses are hooping upward. Place the tub on the half open drawer runners and close the drawer.

17Check the tub clips have reset on both sides of the tub. If not, pull the tub clips forward until the tub clip button is reset.

Important!

Be sure the tub clips on both sides are reset.

9