INSTALLATION INSTRUCTIONS
STEP 7: CONNECTING THE DRAIN HOSE(S)
18a
19 | ” |
| 882.5mm)- | |
| 29 | |||
| 4 |
|
|
|
| / |
|
|
|
| 3 |
|
|
|
| ”34- |
| ” |
|
| 2 |
| 4 |
|
| / |
| / |
|
| 1 |
| 3 | (750mm |
|
|
| 29 | |
|
|
| 2 |
|
|
|
| / |
|
|
|
| 1 |
|
|
| 18b |
|
|
R
DishDrawer® with Hose Joiner (see Plumbing Options).
Remember to slip the wire clip(s) on the drain hose(s) first.
18a Slip a wire clip over each drain hose, then push the hoses into the Drain Hose Joiner firmly, 5 clicks. Position the wire clip(s) between the two positioning ribs on the Drain Hose Joiner.
Attach the Drain Hose Joiner to the waste tee (see Plumbing Options). Ensure a snug fit. If required a hose clamp may be used.
18b When using the standpipe option (see Plumbing Options), hose(s) should not extend further than 43/4” (120mm) down the standpipe, in order to prevent siphoning.
19Attach the Drain Hose Support to the cabinetry (with the screw supplied) to prevent siphoning and to keep the drain hose(s) from kinking. If required, the Drain Hose(s) may be trimmed to a suitable length.
Important!
Minimum hole size to be connected to the waste tee is 1/2” (12.7mm).
Be sure the Drain Hose(s) are fully extended to prevent sagging (see diagram to the left).
The Drain Hose support must be used.
Drain Hose joiner must not support weight of hoses. Keep excess length of Drain Hose on the DishDrawer® side of the Drain Hose support or trim to suit.
STEP 8: CONNECTING THE INLET HOSE
20 | WATER |
| SUPPLY |
WARNING! | Important! | |
DO NOT cut the inlet hose. | ||
DO NOT plug the product in | ||
| ||
at this stage. |
|
20Connect the Inlet Hose to the water supply. Be sure the sealing washer is in place. The hose coupling must be tightened a further half turn after seal contact.
TIP - Turn the water valve ON to check for any leaks.
Alternatively flexible stainless steel hose can be plumbed directly to the inlet valve using a 3/8” brass adaptor (p/n 526161) available from the nearest Fisher & Paykel Authorized Service Agent.
NOTE: SINGLE MODELS DO NOT HAVE A TOE KICK TO INSTALL. PROCEED TO STEP 12 FINAL CHECK LIST.
10
