DCS DS224 Single Models, The Cavity, Water Connection, Water Softener Models, Water Pressure

SINGLE MODELS

SERVICES SPECIFICATIONS

R

w

WATER CONNECTION

Recommended HOT (Maximum 140°F/60°C). Supplied hose to suit 3/8” male compression fitting.

WATER SOFTENER MODELS

Refer to your DishDrawer® User Guide for how to set up your water softener.

WATER PRESSURE	Maximum
Water Softener Models	145 p.s.i. (1000kPa)
Other Models	145 p.s.i. (1000kPa)

	NN




Minimum

14.5 p.s.i. (100kPa)

4.3 p.s.i. (30kPa)

NN
		w
	*  	NN
	NN
w
NN
5BC
4JEF 7JFX	w	
		NN
	NN
	%SBXFS 0QFO

*Depth of product excludes Curvature 3/8” (10mm) and Handle.

DRAIN CONNECTION

Drain Hose Joiner to suit Ø3/4” ± 5/64” and Ø5/8” ± 5/64” waste tees.

ELECTRICAL CONNECTION

110-120 VAC power outlet, 4.5 Amps Minimum.

WEIGHT

Full 107 lb (48kg) Prefinished

Empty 76 lb (34kg) Prefinished

LENGTH OF SERVICES (FROM PRODUCT EXIT POINT)

Drain hose - 889/16” (2250mm) Inlet hose - 687/8” (1750mm) Power supply cord - 44” (1125mm)

NOTE: Services approximately exit product 77/16” (189mm) from left; 215/8” (550mm) from front; 151/2” (393mm) from top.

THE CAVITY

w
NN

w

NN

VœÕ˜ÌiÀ̜«

		×	.PJTUVSF
			1SPUFDUJPO 5BQF
	 w
			
		N
	N
			 w NN TFSWJDFT
			IPMF JNNFEJBUFMZ
w		+	BEKBDFOU UP DPSOFS	+
			DBO CF FJUIFS TJEF
NN	+

	w NN
 w	UISPVHIPVU DBWJUZ
NN
	w NN

w

NN

w
NN

.JOJNVN UIJDLOFTT
PG DBWJUZ
TJEFT JT
w
NN

+

“œˆÃÌÕÀi «ÀœÌiV̈œ˜ Ì>«i

R

These marks indicate mounting screw tab locations

(refer to step 1 page 7)

NOTE: All depth measurements are taken from the front face of the adjacent cabinetry.

NOTE: To align drawer front to adjacent cabinetry, the product to countertop clearance can be increased from 1/8” (3mm).

Important!

Adjacent cabinetry must not extend above cavity base.

WARNING!

Be sure the edges of the services hole are smooth or covered. If the services hole is through a metal partition the hole must be protected with the Edge Protector provided to prevent damage to the power cord or hoses.

5