GM JDP40 manual Install the Range, To Remove and Replace Oven Door, Careand

Page 25

Read these instructions completely and carefully.

Install the Range

WARNING: THE ELECTRICAL POWER TO THE RANGE MUST BE SHUT OFF WHILE LINE CONNECTIONS ARE BEING MADE. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH.

This range is designed to hang from the countertop. It does not rest on the floor.

Install base cabinets 29″ apart, and be sure they are plumb and level before attaching to countertop.

Cut countertop exactly as shown in Step 1. Shave raised edge level to clear 30″-wide rim on rolled edge-style countertops.

Install the wiring junction box in an adjoining cabinet or under the floor (range has 48″ of conduit). Cut 114″ hole to bring conduit to the junction box.

Push the electric conduit through the hole and attach it to the junction box. Leave enough slack in the conduit to allow the range to be pulled forward several inches for service if necessary.

Oven door is heavy. It is advisable to remove door and eliminate its weight as range is lifted into position. See below if you decide to remove the door. Lift the range into position on the countertop.

Safety Instructions

 

Operating Instructions

 

Careand

To Remove and Replace Oven Door

LOCKED (NORMAL)

POSITION

CAUTION: THE DOOR IS HEAVY. FOR SAFE, TEMPORARY STORAGE, LAY THE DOOR FLAT.

1.Open the door to the fully opened position.

2.Pull up the lock located on each hinge support and engage it in the hook of the hinge lever. You may have to apply a little downward pressure on the door to pull the locks fully over the hooks.

3.Grasp the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports.

4.Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disengage the hinge levers.

5.To reinstall the oven door, reverse these steps. Make sure the hinge supports are fully engaged before unlocking the hinge levers.

Cleaning

 

 

Instructions

Installation

 

Troubleshooting

UNLOCKED POSITION FOR

DOOR REMOVAL

HINGE SLOT

 

DOOR REMOVED FROM

25

RANGE

Tips

 

Customer Service

 

Image 25
Contents 318200814 Rev. B GE AppliancesSafety GE & You, a Service PartnershipTroubleshooting Tips Customer ServiceInstallation Care and CleaningCustomer Service OperatingCustomer Service Troubleshooting Instructions Care and Cleaning OperatingTips Instructions Operating Safety InstructionsCleaning the glass cooktop section Troubleshooting TipsCustomer Service Using the surface unitsSafety Instructions Instructions OperatingCareand Cleaning SafetyInstallation Instructions Troubleshooting Tips InstructionsSelecting types of cookware Installation InstructionsSafety Instructions Using the oven controlsCleaning Installation Using the ovenTips Customer Service Operating Instructions How to Set the Oven for BroilingBroiling Guide Broiling guideCare Using the clock and timerInstallation Instructions Using the timed baking and roasting featuresHow to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopTo Adjust the Thermostat Adjust the oven thermostat-Easy to do yourselfType of margarine will affect baking performance Before a Clean Cycle SafetyHow to Set the Oven for Cleaning How to Delay the Start of CleaningTroubleshooting Care and cleaning of the rangeLift-Off Oven Door Operating InstructionsGlass Window Oven Heating ElementsSafety Instructions Oven Light ReplacementOperating Instructions Broiler Pan & GridCustomer Service Troubleshooting Tips Cleaning the glass cooktopNormal Cleaning For Heavy, Burned-On Soil…SafetyInstructions Installation InstructionsCare andCleaning Wiring must conform to National Electric CodesPreparing the Opening Installation InstructionsRead these instructions completely and carefully Prepare for Electrical Connection CareElectrical Connection Install the Lower Filler Trim Panel optional Install the End Cap Filler Blocks optionalTo Remove and Replace Oven Door Install the RangeCareand Anti-Tip Bracket Install the Range Retention L Brace optionalFinal Check Install the Bottom GrilleProblem Possible Causes What To Do Before You Call For Service…Timer do not work Oven temperature tooOven will not self-clean Not unlock Oven not clean after aOven makes Power outageClicking noise A number orCustomer Service GE Electric Range WarrantyGE Will Provide What GE Will Not CoverGE Answer Center Service Telephone Numbers