GM JDP40 manual Anti-Tip Bracket, Install the Range Retention L Brace optional

Page 26

Installation Instructions.

Read these instructions completely and carefully.

Anti-Tip Bracket

This range is equipped with an anti-tip bracket attached to the back of the range with two screws. If countertop thickness is greater than 1/2″, relocate anti-tip bracket to the lower position 1/4″ below.

Slide range into position. Make sure the anti-tip bracket is secured under the rear countertop.

WARNING

■Range must be secured by anti-tip bracket supplied.

■Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury might result from spilled hot liquids or from the range itself.

	Operating	Instructions

	Care and Cleaning

	Installation	Instructions

	Troubleshooting Tips

	Customer Service

ANTI-TIP BRACKET

AT REAR OF RANGE

Install the Range Retention “L” Brace (optional)

When installing this range onto some smooth countertops, it may be necessary to install the Range Retention “L” Braces provided, to prevent movement of the range.

1.Once the range is securely in position in the cabinet opening, position the “L” brace against the side of the cabinet and flush with the front of the range leg.

2.Hold the “L” brace in place and mark the two

holes on the inside of the cabinet.

3. Drill two 1/8″ pilot holes into the cabinet where you just marked. (Caution should be used to avoid drilling through the opposite side of the cabinet.)

4. Attach the “L” brace to the cabinet with the screws provided.

Range Leg

5. Repeat the procedure on the opposite side.

“L” Brace

26

Image 26

Contents GE Appliances 318200814 Rev. BTroubleshooting Tips GE & You, a Service PartnershipSafety Customer ServiceCustomer Service Care and CleaningInstallation OperatingTips Instructions Care and Cleaning OperatingCustomer Service Troubleshooting Safety Instructions Instructions OperatingTroubleshooting Tips Cleaning the glass cooktop sectionSafety Instructions Using the surface unitsCustomer Service Instructions OperatingInstallation Instructions Troubleshooting Tips SafetyCareand Cleaning InstructionsInstallation Instructions Selecting types of cookwareCleaning Using the oven controlsSafety Instructions Tips Customer Service Using the ovenInstallation Broiling Guide How to Set the Oven for BroilingOperating Instructions Broiling guideUsing the clock and timer CareHow to Set an Immediate Start and Automatic Stop Using the timed baking and roasting featuresInstallation Instructions How to Set a Delayed Start and Automatic StopType of margarine will affect baking performance Adjust the oven thermostat-Easy to do yourselfTo Adjust the Thermostat How to Set the Oven for Cleaning SafetyBefore a Clean Cycle How to Delay the Start of CleaningCare and cleaning of the range TroubleshootingGlass Window Operating InstructionsLift-Off Oven Door Oven Heating ElementsOperating Instructions Oven Light ReplacementSafety Instructions Broiler Pan & GridNormal Cleaning Cleaning the glass cooktopCustomer Service Troubleshooting Tips For Heavy, Burned-On Soil…Care andCleaning Installation InstructionsSafetyInstructions Wiring must conform to National Electric CodesRead these instructions completely and carefully Installation InstructionsPreparing the Opening Electrical Connection Care Prepare for Electrical Connection Install the End Cap Filler Blocks optional Install the Lower Filler Trim Panel optionalCareand Install the RangeTo Remove and Replace Oven Door Install the Range Retention L Brace optional Anti-Tip BracketInstall the Bottom Grille Final CheckBefore You Call For Service… Problem Possible Causes What To DoOven will not self-clean Oven temperature tooTimer do not work Not unlock Oven not clean after aClicking noise Power outageOven makes A number orGE Will Provide GE Electric Range WarrantyCustomer Service What GE Will Not CoverService Telephone Numbers GE Answer Center