Toshiba Parallel Port Flash Card Reader user manual Using The CameraConnect Pro Utility

Page 20

Using The CameraConnect Pro Utility

When you load the CameraConnect Pro Drivers in Windows 95 or Windows 98, a utility program is also installed. This utility provides some useful information about the CameraConnect Pro’s installation parameters and the status of any cards which are installed in it.

The CameraConnect Pro Utility can be started from Programs menu. On the Start menu, click Programs, click CameraConnect Pro, then click CameraConnect Utility. The utility will display the dialog box shown below.

Figure 9: The CameraConnect Utility Screen

Three sections of information are provided in the utility’s dialog box. The first block gives PC Parallel Port detection information. The port address indicates which LPT Port the CameraConnect Pro is connected to. The default LPT addresses are listed below.

0x378 LPT1:

0x278 LPT2:

0x3BC LPT3:

20

Image 20
Contents Parallel Port Flash Card Reader Table of Contents Introduction Contacting Actiontec Customer SupportFeatures Connecting the CameraConnect Pro Hardware Getting StartedAT Keyboard Assembly Diagram Installing the Driver and Utility Software Windows 95 orPage Page Windows NT Page Click OK. Follow the on-screen instructions Inserting Devices into the CameraConnect Pro Using the CameraConnect ProFront Panel Functions Inserting a Pcmcia ATA Flash Card Inserting an Smart Media Ssfdc Device Formatting a Card or Smart Media Ssfdc DevicePage Page Viewing, Writing, and Copying Files PrintersOther External Devices Using The CameraConnect Pro Utility CameraConnect Utility ScreenPage Error Messages and Troubleshooting Some Common Error MessagesSome Common Problems CameraConnect Pro will not install. No Drive Letter Assigned Page Appendix a Uninstalling the CameraConnect Pro Uninstalling in Windows 95 or WindowsWindows NT External Port Connectors Appendix B Technical ReferenceDeclaration of Conformity Page Page