MicroSD Card & Battery
1To open VholdR’s back door, place your thumb at the bottom of the door and gently push upwards.
2Your MicroSD memory card is already in place. press on the card until you hear a gentle click and the top of the card has ejected.
Note: VholdR only supports up to a 2GB MicroSD card
3To insert the battery, align the plus sign (+) on the camera with the plus sign (+) on the battery and insert the gold contacts first. Hold the battery tab away from the opening to allow enough space for the battery to slide into place. Slide the tab over the top of the battery and ensure it is resting in one of the grooves on top of the battery.
Note: It is important that the battery clip is firmly engaged to secure the battery in place.
4Close the back door by aligning it slightly above the body of the camera and then sliding downward until it locks into place.
8MicroSD Card & Battery
S/NO 120700 0 0 3 3
Charging the Battery
Your VholdR battery will have some juice out of the box, but we recommend a fresh charge before recording your first adventure. VholdR is designed to charge directly from your computer via the included USB cable.
USB connection
120700S/NO 00 33
charging indicator
1Open VholdR’s back door and connect the USB cable.
2Connect the other end of the USB cable to your computer. USB input: 5V 500mA
Note: The VholdR will charge fastest while not powered on.
3VholdR’s charging indicator light (located inside the back door) will be red when the bat- tery is charging.
4The battery indicator light will turn green once the VholdR is full charged provided the VholdR is powered off while charging. The battery will take about 4 hours to full charge.
5Your VholdR uses a rechargeable
Note: A VholdR wall charger is available as an accessory at www.vholdr.com
Charging the Battery | 9 |
|
|