Preface
Please read this manual carefully before any operation
This Manual covers all proper way of operation of the camera and relevant important notes. We sincerely hope that you read this manual carefully so as to operate the camera properly. 20 minutes’ reading may save you a lot of time.
Special attention: Taking compatibility of SD/MMC card into consideration, you must carry this camera to test the SD/MMC card should you need to buy extra SD/MMC card from thirty parties. Buy SD/MMC card that is compliant with this camera only.
A.Working condition Temperature: 0°~45° Relevant humidity: 45%~80% Air Pressure: 56Kpa~106Kpa
B.Security Precaution
Please do not attempt any method to modify the camera. Otherwise fire, hurt, electric shock or damage to the camera may be caused.
When working under sharp light, do not point the lens straight to sharp light or take a photo, otherwise the image sensor component may be damaged.
Never fire the flash while it is too close to the subject’s eyes. Intense light from the flash can cause eye damage if it is fired too close to the eyes. This is especially true with young children. When using the flash, the camera should be at least one and a half meters from the eyes of the subject.
Do not take photos where there is explosive, which may increase the danger of explosion.
Keep the small parts and accessories of this camera out of reach of small children to prevent accidents.
Keep away from moisture to prevent damage caused by short circuit.
Never load leaking or wet battery into the camera. Any accessory attached to camera should not carry water. In case that any liquid goes into the camera, please stop using and power off the camera immediately.
Do not touch the camera with wet hands to avoid electric shock. Operation in high electromagnetic condition is prohibited.
Try not to store the camera for too long time. Battery should be taken off for storage.
Do not place the camera under high temperature (such as
Try not to unplug the USB cable when transfer of file is in progress, otherwise data lose may be caused. Furthermore, the USB port may be damaged or hang of computer may be caused.
When the camera is working, please place the camera in a closed space because
Before putting the camera into package, please make sure that all accessories like cables are detached, otherwise damage may be caused to cable, and fire or electric shock may be caused. We are not responsible for any damage or loss caused by illegal operation.
1