Samson PS9, PB9, PBPRO7 owner manual Guided Tour PowerBrite Pro7 Front Panel, Samson

Guided Tour - PowerBrite Pro7 Front Panel

1 2 3

4

5

6 7

PowerBrite Pro7

LIGHTOUTLETS

130

127

124

120

117

115

110

105

95

85

PUSH SAMSON PUSH

130

127

124

120

117

115

110

105

95

85

SAMSON

UNSWITCHED 15 AMPERES

VOLTMETERAMMETER

1:Light switch - Use this to turn the fluorescent light in the slide-out drawer on or off. When on, the status light inside this switch is lit red.

2:Outlets switch - Use this to turn the rear-panel outlets on or off. When on, the status light inside this switch is lit red.

3:Voltmeter - This ten-stage LED meter shows the amount of voltage in the electrical signal being received by the PowerBrite Pro7. WARNING: Severe voltage swings can cause damage to connected equipment. If you see the voltmeter changing drastically or rapidly, disconnect the Pro7 until the source of the problem is identified.

4:Slide-out drawer - Contains the Pro7’s fluorescent light, clear plastic diamond lens and back-lit inlay. Use both fingers to press gently on the two “Push” squares on the front and the drawer will slide out towards you. Use the Light switch (see #1 above) to turn the light on or off. The light uses a standard 4 watt fluorescent bulb which is readily available at most hardware stores or electrical suppliers (see page 10 in this manual for information on how to change the bulb). To lock the drawer back into place, gently slide the drawer back in (again using both fingers on the “Push” squares) until it clicks. See the inside back cover of this manual for information about our “Neo-Rack” service which allows the inlay to be replaced with a custom facility logo or name.

5:Ammeter - This ten-stage LED meter shows the amount of current being drawn by equipment connected to the PB Pro7. WARNING: Severe current swings can cause damage to connected equipment.

If you see the ammeter changing drastically or rapidly, disconnect the PB Pro7 until the source of the problem is identified and repaired.

6:Unswitched convenience outlet - This 3-pin AC outlet is active whenever the PB Pro7 is plugged in, regardless of the setting of the Outlets switch (see #2 above).

7:Circuit breaker- This circuit breaker will trip whenever the total load on the PB Pro7 (all rear-panel switched outlets plus the front-panel unswitched convenience outlet) exceeds 15 amps. To reset it, unplug one or more devices so as to reduce the load and gently press the circuit breaker in until you hear it click.

9