Megapixel Cameras and Surveillance Software | User Manual |
•Advanced Mode – In this mode the user can detect all CBC cameras present on the local area network and choose one or more cameras for the installation. Furthermore, Advanced mode allows to set IP of the cameras either automatically (as in Basic mode) or manually, if specific values of IP addresses are required.
The “Advanced” mode provides the following
•
Automatic – this function installs the cameras and verifies their operation and is similar to Automatic function in the Basic modes. However, in the Advanced mode the Automatic installation only acts on those that were highlighted by the user from among the cameras displayed in the Present Cameras window.
•
Find Cameras – this function will locate all CBC cameras that are present on the local network and are accessible by the broadcast request. At the completion of this operation the Installer will show all detected cameras.
•
Set IP - this function allows the user to program specific IP address in the camera. If the camera has already been found by Find Cameras function then the user should highlight that camera, type desired IP address in the New Camera IP window and click Set IP. If the camera can not be found by Find Cameras function due to the fact that existing firewall blocks broadcast requests, the user may be able to still change camera IP by typing both camera Ethernet (MAC) address and desired IP in the boxes at the top of the Installer and clicking Set IP button.
•
Check Network – This feature will find the active network adapters on your system. The results will be displayed in the “Network Cards IP” section of the Advanced window.
•
Clear Selections – This feature will clear/reset any information in the “Present Cameras” section other than the MAC and IP addresses listed.
•
Save/ Exit – This feature will save and the
CBC (America) Proprietary Information | p.14 |