Pelco CC3600 manual Camera Mounting, PIN DD Lens Connections

Page 7

3

4

PIN

DD LENS CONNECTIONS

AI LENS CONNECTIONS

 

 

 

 

 

 

 

1

Control coil negative (-)

Not used

 

 

2

Control coil positive (+)

Lens positive supply

1

2

3

Drive coil positive (+)

Video drive signal

4

Drive coil negative (-)

Ground

 

 

 

 

 

 

 

Figure 2. DD/AI Lens Connector

Camera Mounting

Use a standard 1/4-20 screw (provided) with a maximum thread length of 3/8-inch (10 mm) for top or bottom camera mounting. The mount adapter may be fitted to the top or bottom of the camera. The camera is shipped with the mount adapter located on the top of the camera.

To change the mount adapter position:

1Remove the four screws from the mount adapter located on the top of the camera.

2Remove the trim cover from the bottom of the camera by prying it loose. Place the trim cover on the top of the camera where the mount adapter was removed. Press into place.

3Install the mount adapter to the bottom of the camera. Secure with the four screws removed in step 1.

1

2

3

Figure 3. Camera Mounting

Pelco Manual C1981M-C (8/02)

[ 7 ]

Image 7
Contents Installation/Operation Pelco Manual C1981M-C 8/02 Contents 18. DD/AI Lens Connector Important Safeguards and WarningsModels DescriptionCamera Layout InstallationLens Mounting PIN DD Lens Connections Camera MountingPower Connections Power and Video Connections137 218 348 551 877 Wire Gauge Total Mm2 283 451 716Cable Type Maximum Distance Lens Setup and Focus Procedures Back Focus Adjustment Back Focus AdjustmentSync Synchronization Switch Setting Switch SettingsBLC Backlight Compensation Switch Settings 2 Camera Synchronization General SpecificationsWarranty Warranty and Return Information