Pelco CC3600 manual Important Safeguards and Warnings, 18. DD/AI Lens Connector

IMPORTANT SAFEGUARDS AND WARNINGS

Prior to installation and use of this product, the following WARNINGS should be observed.

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.Do not install near any heat sources, such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Only use attachments/accessories specified by the manufacturer.

10.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combi- nation to avoid injury from tip-over.

11.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, the apparatus does not operate normally, or the apparatus has been dropped.

12.Apparatus shall not be exposed to dripping or splashing, and no objects filled with liquids, such as vases, shall be placed on the apparatus.

13.Warning: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.

14.Caution: Danger of explosion if battery is replaced incorrectly. Replace only with the same or equivalent type.

15.To reduce the risk of shock, do not perform any servicing other than that contained in the oper- ating instructions unless you are qualified to do so.

16.Use only installation methods and materials capable of supporting four times the maximum specified load.

17.Use only UL listed class 2 power supply.

18.DD/AI Lens Connector

The maximum load for a direct drive lens must not exceed 25 mA. The maximum load for an auto-iris lens must not exceed 50 mA.

The product and/or manual may bear the following marks:

This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit.

This symbol indicates that there are impor- tant operating and maintenance instructions in the literature accompanying this unit.

C AU T I O N :

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

Please thoroughly familiarize yourself with the information in this manual prior to installation and operation.

[ 4 ] Pelco Manual C1981M-C (8/02)