Pelco CC3600 manual Power and Video Connections, Power Connections

Page 8

POWER AND VIDEO CONNECTIONS

To connect the camera power and video do the following:

1.Remove the rear cover from the camera (refer to Figure 1). Thread cabling through the rear cover.

2.Connect the power cable to the two pin power connector on the back of the camera using the terminal block connector provided. Refer to Table A for the recommend wire gauge to use for the installation.

3.Connect a video cable to the SIGNAL OUT connector (BNC) on the back of the camera. Refer to Table B for the type of video coaxial cable to use.

4.Reattach the rear cover to the back of the camera.

Power Connections

CC3500 and CC3600 Series cameras are designed to operate from a 12 VDC or 24 VAC power sup- ply. The power supply connections are shown in Figure 4. The LED on the back panel of the camera indicates that power is connected. Use only a Class 2 isolated power supply. Power consumption is less than 5 watts.

CLASS 2

ISOLATED

POWER

SUPPLY

CLASS 2

ISOLATED

POWER

SUPPLY

24 VAC

12 VDC

Figure 4. Power Supply Connections

To connect the camera power and video:

1.Remove the cosmetic trim ring from the camera (refer to Figure 1). Thread cabling through the rear cover.

2.Connect the power cable to the two pin power connector on the back of the camera using the terminal block connector (provided). Refer to Table A for the recommend wire gauge and wiring distances.

3.Connect a video cable to the SIGNAL OUT connector (BNC) on the back of the camera. Refer to Table B for the type of video coaxial cable to use.

4.Reattach the trim ring to the back of the camera.

[ 8 ] Pelco Manual C1981M-C (8/02)

Image 8
Contents Installation/Operation Pelco Manual C1981M-C 8/02 Contents Important Safeguards and Warnings 18. DD/AI Lens ConnectorDescription ModelsLens Mounting InstallationCamera Layout Camera Mounting PIN DD Lens ConnectionsPower and Video Connections Power ConnectionsCable Type Maximum Distance Wire Gauge Total Mm2 283 451 716137 218 348 551 877 Lens Setup and Focus Procedures Back Focus Adjustment Back Focus AdjustmentSwitch Settings Sync Synchronization Switch SettingBLC Backlight Compensation Switch Settings 2 Camera Synchronization Specifications GeneralWarranty and Return Information Warranty